The China Geological Survey (CGS) has carried out a large number of surveys and core drilling over the deepwater area of Qiongdongnan Basin (QDNB) in the South China Sea and discovered the natural gas hydrate system controlled by the gas chimney with a high geothermal gradient. The complex hydrate system consists of a sandy hydrate reservoir distributed around a lateral transition gas-hydrate mixed zone and a free gas zone in the middle. The hydrate and gas are distributed in the same layer, which is thin but potentially valuable for commercial exploitation. In this paper, a geological model of the target hydrate system in QDNB was established based on the results of several rounds of drilling. The method of numerical simulation was utilized to assess the production capacity of the target hydrate system and clarify the evolution of hydrate and gas saturation distribution with different well positions. The simulation results indicate that the producer well built in the center of the highly-saturated hydrate zone has a limited gas production capacity, with a cumulative production of only 7.25 × 10⁶ m³ in 9 years. The well built at the boundary of the hydrate zone can rapidly link up the gas in the transition zone through a large production pressure differential, but it lacks control over the hydrates and its dissociated gas in the transition zone—the cumulative gas production volume from hydrate accounts for only 12.3%. As for the wells built in the transition zone and gas zone, they can directly invoke the free gas production capacity. Free gas is produced as the formation pressure reduces and hydrate is induced to dissociate, making the gas from the hydrate the subsequent production capacity. The cumulative production can exceed 6 × 10⁸ m³ in 9 years. The stable production duration can extend to 2645 days, and the cumulative proportion of gas at the wellhead from hydrate reaches close to 30%. It is necessary to avoid the free water layer. The bottom water coning would improve the water production by 40% and shorten the stable production duration. In summary, the complex hydrate system of this type in the QDNB has the potential for industrialized exploitation. In the future, the well group can be used for the further improvement of the hydrate utilization rate.

In situ electric heating is an important method used to increase production capacity during the extraction of natural gas hydrates. This work numerically evaluated the sensitivity of different heating parameters on gas production behavior with a vertical well depressurization in the Shenhu Sea area hydrate reservoir, the production pressure difference of 4 MPa, and continuous depressurization for 1080 days. The results showed that the in situ electric heating method can effectively enhance production capability by promoting hydrate dissociation and eliminating secondary hydrates. Compared with scenarios without heating, implementing whole wellbore heating (100 W/m) increases cumulative gas production (V_g) by 118.56%. When intermittent heating is applied to the local wellbore (15 m) located in the three-phase layer (with an interval of 30 days) and stops heating in advance at 480 days, there is no significant difference in V_g compared to the whole wellbore heating case, and the cumulative heat input is only 4.76%. We recommend considering intermittent heating of the local wellbore and stopping heating in advance during vertical well depressurization as this approach significantly reduces heating energy consumption while simultaneously improving production capacity.

In this paper, a one-dimensional model of gas–water two-phase productivity for hydrate depressurization is established, which takes into account permeability variation and gas–water two-phase flow. By solving the coupled algebraic equations of dissociation front position, equilibrium temperature, and pressure in an iterative scheme, the movement law of the hydrate dissociation front and the evolution process of temperature and pressure near the well were obtained, and the effects of bottom hole pressure, reservoir temperature, and hydrate saturation on productivity were analyzed. The results show that the hydrate reservoir is divided into a decomposed zone and an undecomposed zone by the dissociation front, and the temperature and pressure gradients of the former are greater than those of the latter. Reducing bottom hole pressure, increasing reservoir temperature, and increasing hydrate saturation all lead to an increase in temperature and pressure gradient in the decomposed zone. Methane gas production is a sensitive function of bottom hole pressure, reservoir temperature, and hydrate saturation. The lower the bottom hole pressure, the higher the reservoir temperature, the lower the hydrate saturation (within a certain range), and the higher the gas production rate. The trend of the water production curve is the same as that of gas, but the value is 3–4 orders of magnitude smaller, which may be due to the large difference in the viscosity of gas and water, and the gas seepage speed is much larger than that of water.