We report the first experimental observation of nonlinear standing waves excited by plasma-series-resonance-enhanced harmonics in low pressure, very high frequency, parallel plate, capacitively coupled plasmas. Spatial structures of the harmonics of the magnetic field, measured by a magnetic probe, are in very good agreement with simulations based on a nonlinear electromagnetics model. At relatively low pressure, the nonlinear sheath motion generates high-order harmonics that can be strongly enhanced near the series resonance frequencies. Satisfying certain conditions, such nonlinear harmonics induce radial standing waves, with voltage and current maxima on axis, resulting in center-high plasma density. Excitation of higher harmonics is suppressed at higher pressures.
20 April 2017 in Plasma Sources Science and Technology
Self-organized striated structures of the plasma emission have recently been observed in capacitive radio-frequency CF 4 plasmas by phase resolved optical emission spectroscopy (PROES) and their formation was analyzed and understood by particle in cell/Monte Carlo collision (PIC/MCC) simulations (Liu et al 2016 Phys. Rev. Lett.116 255002). The striations were found to result from the periodic generation of double layers due to the modulation of the densities of positive and negative ions responding to the externally applied RF potential. In this work, an in-depth analysis of the formation of striations is given, as well as the effect of the driving frequency on the plasma parameters, such as the spatially modulated charged species densities, the electric field, and the electron power absorption is studied by PROES measurements, PIC/MCC simulations, and an ion–ion plasma model. The measured spatio-temporal electronic excitation patterns at different driving frequencies show a high degree of consistency with the simulation results. The striation gap (i.e., the distance between two ion density maxima) is found to be inversely proportional to the driving frequency. In the presence of striations the minimum ( ) ion densities in the bulk region exhibit an approximately quadratic increase with the driving frequency. For these densities, the eigenfrequency of the ion–ion plasma is near the driving frequency, indicating that a resonance occurs between the positive and negative ions and the oscillating electric field inside the plasma bulk. The maximum ion densities in the plasma bulk are found not to exhibit a simple dependence on the driving frequency, since these ion densities are abnormally enhanced within a certain frequency range due to the ions being focused into the ‘striations’ by the spatially modulated electric field inside the bulk region.
Capacitively coupled radio-frequency (CCRF) CF4 plasmas have been found to exhibit a self-organized striated structure at operating conditions, where the plasma is strongly electronegative and the ion-ion plasma in the bulk region (largely composed of and F– ions) resonates with the excitation frequency. In this work, we explore the effects of the gas pressure, the RF voltage, and the electrode gap on this striated structure by phase resolved optical emission spectroscopy and particle-in-cell/Monte Carlo collisions simulations. The measured electronic excitation patterns at different external parameters show a good general agreement with the spatio-temporal plots of the ionization rate obtained from the simulations. For a fixed driving frequency, the minima of the or F– ion densities (between the density peaks in the bulk) are comparable and independent of other external parameters. However, the ion density maxima generally increase as a function of the pressure or RF voltage, leading to the enhanced spatial modulation of plasma parameters. The striation gap (defined as the distance between two ion density peaks) is approximately inversely proportional to the pressure, while it exhibits a weak dependence on the RF voltage and the electrode gap. A transition between the striated and non-striated modes can be observed by changing either the pressure or the RF voltage; for 13.56 and 18 MHz driving frequencies, we present a phase diagram as a function of the pressure and voltage amplitude parameters.
1 July 2019 in Plasma Sources Science and Technology
It is well known that the plasma non-uniformity caused by the standing wave effect has brought about great challenges for plasma material processing. To improve the plasma uniformity, a low-frequency (LF) power source is introduced into a 100 MHz very-high-frequency (VHF) capacitively coupled argon plasma reactor. The effect of the LF parameters (LF voltage amplitude ϕL and LF source fL ) on the radial profile of plasma density has been investigated by utilizing a hairpin probe. The result at a low pressure (1 Pa) is compared to the one obtained by a 2D fluid-analytical capacitively coupled plasma model, showing good agreement in the plasma density radial profile. The experimental results show that the plasma density profile exhibits different dependences on ϕL and fL at different gas pressures/electrode driven types (i.e., the two rf sources are applied on one electrode (case I) and separate electrodes (case II)). At low pressures (e.g., 8 Pa), the pronounced standing wave effect revealed in a VHF discharge can be suppressed at a relatively high ϕL or a low fL in case I, because the HF sheath heating is largely weakened due to strong modulation by the LF source. By contrast, ϕL and fL play insignificant roles in suppressing the standing wave effect in case II. At high pressures (e.g., 20 Pa), the opposite is true. The plasma density radial profile is more sensitive to ϕL and fL in case II than in case I. In case II, the standing wave effect is surprisingly enhanced with increasing ϕL at higher pressures; however, the center-high density profile caused by the standing wave effect can be compensated by increasing fL due to the enhanced electrostatic edge effect dominated by the LF source. In contrast, the density radial profile shows a much weaker dependence on ϕL and fL in case I at higher pressures. To understand the different roles of ϕL and fL , the electron excitation dynamics in each case are analyzed based on the measured spatio-temporal distributions of the electron-impact excitation rate by phase resolved optical emission spectroscopy.
1 December 2020 in Plasma Sources Science and Technology
During the initiation of a gas discharge under radio-frequency excitation we find that the system undergoes a sequence of distinct electron power absorption modes, while its impedance changes on the nanosecond timescale within the pre-breakdown, breakdown and post-breakdown phases. The experimental results for the spatiotemporal distribution of the excitation rate as well as other plasma parameters during the breakdown process are confirmed by particle-based kinetic simulations. The phenomenon is followed by an analytical model that sheds light on the temporal variation of the current and voltage waveforms as well as their phase difference leading to the rapid variation of the impedance during the build-up of the plasma.