The recently introduced Coaxial Laser Wire Deposition technology can become a new promising method for remanufacturing high-complexity and expensive cutting tools (e.g., flat broach), which will have a significant impact on their service life. In addition, it is an innovative approach to tool management. An analysis of the feasibility of processing cobalt-added HSS powder steels was carried out for single clads and multilayer structures. The effect of process parameters (laser, beam power, travel speed, wire feed rate) on geometric properties, hardness and microstructure was discussed. In order to avoid cracking during multilayer deposition, an additional preheating to 320 °C was applied. Two sets of process parameters with high and low heat input were obtained. Both sets lead to crack-free structures that fulfill geometric (≥2.5 mm in height) and hardness (≥700 HV) requirements.

Laser cladding technology is a well-established process, commonly used for deposition of improved-property coatings, repair of machine parts and additive manufacturing. Currently, in terms of application of laser cladding, the method based on powder deposition is much more common, as the use of an adapted nozzle allows the coaxial and direction-independent feeding of additional material into the weld pool. However, laser cladding with powder also has some significant drawbacks, e.g., limited powder feeding and melting efficiency, lower productivity and the resulting dust that poses a health risk to operators. The solution to these limitations is the use of additional material in the form of wire. To maintain the ability to coaxially feed the wire to the laser beam interaction point, a specialized cladding head is necessary. In mentioned system the laser beam, while being passed through the optical system, is divided into three separate beams that are focused on the substrate on the working point of the head. In this study, the COAXwire cladding head was integrated into the robot station and laser cladding process was carried out to determine the influence of the processing parameters on the deposition results. The parameters of the cladding system were identified, including the measurement of laser beam caustic. The experimental trials were carried out using AISI 316L wire deposited on S420MC substrate. The effect of the processing parameters on the geometry of the clad was determined with particular emphasis on the wire feeding.