A new method for solving the shear stress and the effective viscosity of Eyring shear-thinning fluid in thermal elastohydrodynamic lubrication (EHL) was proposed and applied to two models. Model 1 is the thermal EHL model with one-direction velocity, and model 2 is the spinning thermal EHL model in which the velocity varies with coordinates. Comparisons between the new and the existing method were carried out. Results show that only replacing the shear strain rate of model 1 with that of model 2, the shear stress and the effective viscosity of model 2 for Eyring shear-thinning fluid can be obtained. For model 1, results obtained with the two methods are the same. The new method can be qualified and applied into model 2. It is proved that the new method has higher efficiency for shear-thinning fluid than the existing method. Therefore, the new method is more efficient and can be used for spinning Eyring shear-thinning thermal EHL.
An optical interference test rig with spinning elastohydrodynamic lubrication (EHL) was established to investigate the spinning lubrication performance under different oil-supply conditions. Variations in the shape and thickness of the film versus the velocity, the load, and the spinning factor under fully flooded lubrication were discussed, and the effects of the inlet-starvation position and oil-supply quantity were analyzed. The results show that the symmetry for the classical horseshoe shape does not exist under both spinning–rolling and spinning–sliding EHL conditions. Different from spinning–rolling, a dimple is generated more easily under the spinning–sliding condition. The dimple is related to the load and the speed. The effects of the inlet-starvation position on spinning EHL are different. When the inlet starvation is on the low-speed side of the contact, that is, proximal to the center of rotation, the inlet-starvation position extends from the proximal side to the center of rotation to the distal side to the center of rotation, i.e., the high-speed side of the contact, which is starved easily. When the starvation happens on the high-speed side, i.e., distal to the center of rotation, the starvation at this position becomes much more severe, and lubrication failure and a risk of wear will occur. In addition, the effects of oil-supply quantity on spinning EHL are important.