An efficient meta-heuristic algorithm, named beetle swarm optimization (BSO), is proposed to localize and quantify structural damage using limited vibration measurement data. The beetle antennae search (BAS) algorithm that imitats a random walking mechanism in nature was recently developed to solve the optimization problem. However, the ratio of convergence of this algorithm significantly relys on the random direction and deviation for high-dimensional problems. To overcome this shortcoming, the BSO inspired by the swarm intelligence strategy is proposed. In the iterative search process of the BSO, each beetle swarm moves in a random direction like the BAS and the swarm of beetles is cognitive with the optimal one for the searching behavior. Consequently, the optimal one is updated step by step until a better beetle appears. To demonstrate the capability and robustness of the BSO, numerical and experimental studies using limited vibration measurement data of an offshore wind turbine structure are carried out for structural damage identification. An novel objective function is established by combining natural frequencies with mode shapes of the structure. The numerical results show that the BSO can accurately localize and quantify various types of damage even in a noise and temperature variations polluted environment. Moreover, it has higher accuracy and faster convergence speed than the BAS and the particle swarm optimization (PSO) algorithms. These promising performances could contribute to establishing a structural monitoring system for safety assurance of wind turbine structures.
This paper presents a robust damage identification scheme in which damage is predicted by solving the cross-modal strain energy (CMSE) linear system of equations. This study aims to address the excessive equations issue faced in the assemblage of the CMSE system. A sensitivity index that, to some extent, measures how the actual damage level vector satisfies each CMSE equation, is derived by performing an analysis of the defined residual’s sensitivity to damage. The index can be used to eliminate redundant equations and enhance the robustness of the CMSE system. Moreover, to circumvent a potentially ill-conditioned problem, a previously published iterative Tikhonov regularization method is adopted to solve the CMSE system. Some improvements to this method for determining the iterative regularization parameter and regularization operator are given. The numerical robustness of the proposed damage identification scheme against measurement noise is proved by analyzing a 2-D truss structure. The effects of location and extent of damage on the damage identification results are investigated. Furthermore, the feasibility of the proposed scheme for damage identification is experimentally validated on a beam structure.
10 January 2020 in Structural Control and Health Monitoring
A damage detection process can be significantly enhanced if the nonlinear effects can be used when extracting damage-sensitive features from measured signals. The coherence function is typically used for nonlinearity identification by determining the extent of the output power linearly correlated with the input. However, the excitations are usually difficult to measure in actual tests. To overcome this limit, this article presents a signal-segments cross-coherence method for nonlinearity identification. By defining a signal-segments cross-coherence matrix and signal-segments cross-coherence index, the method can visually and quantitatively indicate the presence of nonlinearity. The innovation of the new method is that the coherence analysis process only depends on a single output signal, where input and baseline signals are not required. Then, a novel structural damage localization index is constructed by multi-point comparing of the signal-segments cross-coherence indices, based on the assumption that all the measured signals from different points on the structure have the same frequency bandwidth and components. To meet this requirement, a newly proposed signal decomposition method called analytic mode decomposition method is adopted. Numerical studies on a duffing oscillator and a 10 degree-of-freedom spring-damping-mass system were performed to demonstrate the nonlinear identification process and investigate the effectiveness and robustness of the signal-segments cross-coherence-based damage detection method. The results show that the signal-segments cross-coherence method can effectively indicate the appearance of nonlinearity by the signal-segments cross-coherence matrix and signal-segments cross-coherence index with strong noise robustness. And the proposed damage localization index can accurately detect the weak nonlinear damage even with severely noise-polluted signals. To further investigate the applicability of the new method, an experimental study was conducted on a steel simplified scale model of a monopile offshore wind turbine support structure. The results demonstrate that the proposed signal-segments cross-coherence method and the new damage localization index can be used to detect the bolt-loosening damage of the steel structure only with output signals.