Decarbonization of the maritime sector to achieve ambitious IMO targets requires the combination of various technologies. Among alternative fuels, ammonia (NH3), a carbon-free fuel, is a good candidate; however, its combustion produces NOx, unburnt NH3 and N2O—a strong greenhouse gas (GHG). This work conducts a preliminary assessment of the emission control challenges of NH3 application as fuel in the maritime sector. Commercial catalytic technologies are applied in simulated NH3 engine exhaust to mitigate NH3 and NOx while monitoring N2O production during the reduction processes. Small-scale experiments on a synthetic gas bench (SGB) with a selective-catalytic reduction (SCR) catalyst and an ammonia oxidation catalyst (AOC) provide reaction kinetics information, which are then integrated into physico-chemical models. The latter are used for the examination of two scenarios concerning the relative engine-out concentrations of NOx and NH3 in the exhaust gas: (a) shortage and (b) excess of NH3. The simulation results indicate that NOx conversion can be optimized to meet the IMO limits with minimal NH3 slip in both cases. Excess of NH3 promotes N2O formation, particularly at higher NH3 concentrations. Engine-out N2O emissions are expected to increase the total N2O emissions; hence, both sources need to be considered for their successful control.
22 May 2026 in Emission Control Science and Technology
The decarbonization of maritime transport necessitates the adoption of carbon-free fuels, with ammonia (NH₃) emerging as a promising candidate. However, its incomplete combustion, resulting in unburnt NH 3 , and the formation of nitrogen oxides (NOₓ) and nitrous oxide (N₂O), a potent greenhouse gas (GHG), pose significant challenges for emission control. To address these challenges, experimental kinetic data of Fe-BEA, Co-based, and Pt-based catalysts are incorporated into physico-chemical models. Model validation against the experimental data confirms the accurate prediction of NH₃, NOₓ, and N₂O conversion trends. The model is subsequently employed to design and optimize the Exhaust Aftertreatment System (EATS) layouts, including Selective Catalytic Reduction (SCR), SCR with Ammonia Slip Catalyst (ASC), and hybrid Co–Pt ASC configurations, across a range of engine-out NH₃/NOₓ ratios and combustion efficiencies. The results demonstrate that while NOₓ and NH₃ emissions can be effectively mitigated, N₂O formation in ASC-equipped systems constrains total GHG reduction to approximately 76% compared to conventional diesel operation. A hybrid ASC configuration combining Co and Pt catalysts successfully reduced N₂O selectivity, achieving up to 50% additional GHG reduction.