Graphene materials with different characteristics in terms of sheet size and defects (structural and/or functional groups) were obtained by the reduction with hydrazine of two graphene oxides with similar oxygen content, but with functional groups of different type and location. The oxides were prepared from two synthetic graphites with distinct crystalline structure. Our research has obtained experimental evidence of a greater reactivity of the oxygen functional groups located in the interior of the aromatic domains on the basal planes (mainly epoxy) and a lower reactivity of oxygen functional groups located at the edges (mainly carboxyl and OH). Furthermore, these edge-located groups were found to be responsible for hydrogen bonding lateral interactions between sheets (these occur through the residual OH groups), which cause a substantial increase in the size of the reduced graphene oxide with respect to that of the parent graphene oxide. These results offer a way to tailor the characteristics of graphene materials for diverse applications.
Al2O3/graphene and BaTiO3/graphene composites with different concentrations of the conductive second phase, both below and above the percolation threshold, were prepared by the traditional ceramic processing route followed by spark plasma sintering. It is shown that the addition of graphene pins the grain growth of the ceramic matrix grains, leading to a change of the microstructure at low filler concentrations. As a consequence, the composites exhibit two percolation thresholds and their dielectric properties are not only determined by the dielectric properties of the constituents and their relative fractions but also the microstructure of the composite must be considered. Additionally, a giant increase of the dielectric constant has been found around the percolation thresholds in barium titanate–graphene composites. In particular, values of the dielectric constant up to 45,000 and 15,000 were found at 1 kHz in composites containing 0.4 and 0.6 wt. % graphene, respectively.
24 April 2014 in Journal of Colloid and Interface Science
CVD-grown multiwalled carbon nanotubes were purified by applying four different treatments with increasing oxidation severity. The growing severity of the treatment results in progressive oxygen functionalization of the surface along with introduction of an increasing quantity of defects on the carbon nanotube walls. Iridium–N-heterocyclic carbene complexes were covalently anchored to those oxidized surfaces through their surface carboxylic acids via acetyl linkers. The carbon nanotube-based iridium–NHC hybrid materials developed are active in the hydrogen-transfer reduction of cyclohexanone to cyclohexanol with 2-propanol/KOH as hydrogen source but with rather different activity. The catalytic activity of the hybrid catalysts is strongly influenced by the type and amount of oxygenated functionalization resulting from the treatment applied to the support, being the most active and the most oxidized material.
This paper focuses on the development of patterned graphene/substrate by means of green nanosecond pulse laser irradiation. Monolayer graphene samples supported on a Si/SiO2 substrate were patterned using 532 nm laser irradiation under fluence conditions ranging from 31 mJ cm−2 to 4240 mJ cm−2. Raman spectroscopy was used to investigate the effect of laser irradiation on the graphene. It was found that at 356 mJ cm−2 selective ablation of the graphene occurs. However, at fluence values above 1030 mJ cm−2 (when damage to the substrate is observed) no ablation of the graphene takes place. In contrast, its graphenic structure was found to have been modified. Only at fluence values where the ablation of the substrate occurs, is graphene eliminated in an area almost equivalent to that of the ablated substrate. In this case, additional damage to the graphene sheet edges is produced. The increment in the number of oxygenated functional groups in these regions, as measured by x-ray photoelectron spectroscopy (XPS), suggests that this damage is probably caused by thermal phenomena during the ablation of the substrate.