In this article, our experimental study of the dynamic dielectric behaviour of transformer oil-based ferrofluid with magnetite nanoparticles is presented. Frequency-dependent dielectric permittivity and dissipation factor were measured within the frequency range from 20 Hz to 2 MHz by a capacitance method. The ferrofluid samples were placed in a liquid crystal cell, and experiments were carried out in an electromagnetically anechoic chamber. Two polarization processes and corresponding relaxations were revealed within the applied frequency range. Schwarz theory of electric double layer polarization is used to explain the low frequency relaxation maximum. Moreover, the shift of the maximum position towards higher frequencies is observed as the magnetic volume fraction in the ferrofluid increases. The related decrease in relaxation time due to higher counterion mobility is analysed. Reduced electric field intensity due to depolarization field, which is dependent on the particle concentration, is proposed as the reason for the maxima shift. This assumption is wholly supported by a complementary experiment.
This review is focused on the research of dielectric fluids, especially commonly used power transformer oils enhanced by nanoparticles, i.e., nanofluids. There are differences between various combinations of base fluids and nanoparticles prepared in different ways. The main goal of this review was to present recent research in this field sorted by the used nanoparticles. Nanofluids based on mineral oils, natural, or synthetic esters were investigated in terms of the nature of nanoparticles, particularly Al2O3, TiO2, Fe2O3, Fe3O4, graphene, fullerene, and others. The combinations of environmentally friendly oils and nanoparticles were presented. Finally, the article focused on the description of current dielectric fluids usable in power transformers and the possibilities of improving new and existing fluids with nanoparticles, especially their physical, dielectric, and chemical properties, but with regard to environmental aspects.
An experimental study of magnetic colloidal particles cluster formation induced by an external electric field in a ferrofluid based on transformer oil is presented. Using frequency domain isothermal dielectric spectroscopy, we study the influence of a test cell electrode separation distance on a low-frequency relaxation process. We consider the relaxation process to be associated with an electric double layer polarization taking place on the particle surface. It has been found that the relaxation maximum considerably shifts towards lower frequencies when conducting the measurements in the test cells with greater electrode separation distances. As the electric field intensity was always kept at a constant value, we propose that the particle cluster formation induced by the external ac electric field accounts for that phenomenon. The increase in the relaxation time is in accordance with the Schwarz theory of electric double layer polarization. In addition, we analyze the influence of a static electric field generated by dc bias voltage on a similar shift in the relaxation maximum position. The variation of the dc electric field for the hysteresis measurements purpose provides understanding of the development of the particle clusters and their decay. Following our results, we emphasize the utility of dielectric spectroscopy as a simple, complementary method for detection and study of clusters of colloidal particles induced by external electric field.
1 August 2019 in IEEE Transactions on Dielectrics and Electrical Insulation
An experimental study of dielectric permittivity and dissipation factor of transformer oil-based magnetic nanofluid is reported in this paper. The investigated nanofluid consists of a commercial transformer oil and iron oxide nanoparticles (0.93 % solid volume fraction) coated with oleic acid as a stabilizing agent. Both, the transformer oil and the nanofluid were subjected to measurements of dielectric permittivity and dissipation factor under 1 kV at a power frequency of 50 Hz in the temperature range from 303 to 373 K. The compared results show that the magnetic nanofluid exhibits approximately 4 orders of magnitude greater dielectric losses than the transformer oil. This raised a question about the suitability of such a nanofluid for cooling applications in a transformer. Therefore, the cooling effectiveness of the nanofluid was tested in a model single-phase power transformer under 4.3 kVA load. The prototype transformer was designed with the aim to monitor its temperature at various locations during the load test. It was found that the cooling with the lossy nanofluid does not result in the deterioration of the thermal conditions of the transformer as compared to the cooling with the transformer oil. On the contrary, the tested nanofluid provides a slight decrease in the average transformer temperature rise. Possible reasons accounting for the slight enhancement in the transformer cooling are discussed. The increased thermal conductivity and development of thermomagnetic convection are considered as primary reasons of the cooling effect.
Progress in electrical engineering puts a greater demand on the cooling and insulating properties of liquid media, such as transformer oils. To enhance their performance, researchers develop various nanofluids based on transformer oils. In this study, we focus on novel commercial transformer oil and a magnetic nanofluid containing iron oxide nanoparticles. Three key properties are experimentally investigated in this paper. Thermal conductivity was studied by a transient plane source method dependent on the magnetic volume fraction and external magnetic field. It is shown that the classical effective medium theory, such as the Maxwell model, fails to explain the obtained results. We highlight the importance of the magnetic field distribution and the location of the thermal conductivity sensor in the analysis of the anisotropic thermal conductivity. Dielectric permittivity of the magnetic nanofluid, dependent on electric field frequency and magnetic volume fraction, was measured by an LCR meter. The measurements were carried out in thin sample cells yielding unusual magneto-dielectric anisotropy, which was dependent on the magnetic volume fraction. Finally, the viscosity of the studied magnetic fluid was experimentally studied by means of a rheometer with a magneto-rheological device. The measurements proved the magneto-viscous effect, which intensifies with increasing magnetic volume fraction.
Ferrofluids typically respond to magnetic fields and can be manipulated by external magnetic fields. Here, we report on formation of visually observable patterns in a diluted low-polarity ferrofluid exposed to external electric fields. This presents a specific type of ferrofluid structure driven by a combined effect of electrohydrodynamics and electrical body forces. The free charge and permittivity variation are considered to play a key role in the observed phenomenon. The corresponding changes in the ferrofluid structure have been found at nanoscale as well. By small-angle neutron scattering (SANS), we show that the magnetic nanoparticles aggregate in direct current (dc) electric field with a strong dependence on the field intensity. The anisotropic aggregates preferably orient in the direction of the applied electric field. Conducting SANS experiments with alternating current (ac) electric fields of various frequencies, we found a critical frequency triggering the aggregation process. Our experimental study could open future applications of ferrofluids based on insulating liquids.