With the advantages of high tensile, bending, and shear strength, steel fiber concrete structures have been widely used in civil engineering. The health monitoring of concrete structures, including steel fiber concrete structures, receives increasing attention, and the Electromechanical Impedance (EMI)-based method is commonly used. Structures are often subject to changing axial load and ignoring the effect of axial forces may introduce error to Structural Health Monitoring (SHM), including the EMI-based method. However, many of the concrete structure monitoring algorithms do not consider the effects of axial loading. To investigate the influence of axial load on the EMI of a steel fiber concrete structure, concrete specimens with different steel fiber content (0, 30, 60, 90, 120) (kg/m³) were casted and the Lead Zirconate Titanate (PZT)-based Smart Aggregate (SA) was used as the EMI sensor. During tests, the step-by-step loading procedure was applied on different steel fiber content specimens, and the electromechanical impedance values were measured. The Normalized root-mean-square deviation Index (NI) was developed to analyze the EMI information and evaluate the test results. The results show that the normalized root-mean-square deviation index increases with the increase of the axial load, which clearly demonstrates the influence of axial load on the EMI values for steel fiber concrete and this influence should be considered during a monitoring or damage detection procedure if the axial load changes. In addition, testing results clearly reveal that the steel fiber content, often at low mass and volume percentage, has no obvious influence on the PZT’s EMI values. Furthermore, experiments to test the repeatability of the proposed method were conducted. The repeating test results show that the EMI-based indices are repeatable and there is a great linearity between the NI and the applied loading.

Currently, the frame structures with special-shaped concrete-filled steel tubular columns have been widely used in super high-rise buildings. Those structural members can be used to improve architectural space. To investigate the seismic behavior of spatial composite frames that were constructed by connecting steel beams to L-shaped concrete-filled steel tubular (CFST) columns, a finite element analysis (FEA) model using commercial finite element software ABAQUS was proposed to simulate the behavior of the composite spatial frames under a static axial load on columns and a fully-reversed lateral cyclic load applied to frames in this paper. Several nonlinear factors, including geometry and material properties, were taken into account in this FEA model. Four spatial specimens were designed, and the corresponding experiments were conducted to verify the proposed FEA model. Each testing specimen was two-story structure consisting of eight single span steel beams and four L-shaped CFST columns. The test results showed that the proposed FEA model in this paper could evaluate the behavior of the composite spatial frames accurately. Based on the results of the nonlinear analysis, the stress developing progress of columns is investigated. The load transferring mechanism and failure mechanism are also determined. The results are discussed and conclusions about the behavior of those spatial frame structures are presented.

Embedded Lead Zirconate Titanate (PZT) transducers have been widely used in research related to monitoring the health status of concrete structures. This paper presents a dynamic model of an embeddable PZT transducer with a waterproof layer and a protecting layer. The proposed model is verified by finite-element method (FEM). Based on the proposed model, the factors influencing the dynamic property of the embeddable PZT transducers, which include the material and thickness of the protecting layer, the material and thickness of the waterproof layer, and the thickness of the PZT, are analyzed. These analyses are further validated by a series of dynamic stress transfer experiments on embeddable PZT transducers. The results show that the excitation frequency can significantly affect the stress transfer of the PZT transducer in terms of both amplitude and signal phase. The natural frequency in the poling direction for the PZT transducer is affected by the material properties and the thickness of the waterproof and protecting layers. The studies in this paper will provide a scientific basis to design embeddable PZT transducers with special functions.