With a growing interest in the application of carbon fibre Sheet Moulding Compound (SMC), a number of commercial software packages have been developed for the simulation of compression moulding of SMC. While these packages adopt different algorithms and meshing strategies, the constitutive material model and processing control are usually adapted from injection moulding process simulation. Little has been done in the literature for assessing the capabilities of these software as design tools, and more importantly, validating the process simulation results using experimental data. This paper aims to provide an independent and comprehensive assessment of existing well-known process simulation software for SMC compression moulding. The selected software will be compared in terms of material models, and available processing settings in order to determine their robustness as a compression moulding design tool. The predictive accuracy of the software will also be assessed by comparing the compression force and filling patterns against the experimental data.
Discontinuous fibre reinforced composites enable the manufacture of integrated structural components via the complex flow process of compression moulding. However, such processes can lead to the formation of detrimental weld-lines. Here, the meso-structure of carbon fibre sheet moulding compounds (C-SMC) was analysed using conventional non-destructive techniques and automated eddy current (EC) scanning, as well as destructive methods, in an attempt to identify defects such as weld-lines in this class of materials. Compression-moulded plaques with forced weld-lines in two different configurations (adjacent and opposing flow joints) were analysed, showing up to 80% strength reduction versus a defect-free plaque. The EC-determined local fibre orientation and elucidated local microstructure matched those obtained using conventional techniques, showing a dramatic fibre tow alignment parallel to the weld-lines. It was found that failure occurred in proximity to the “non-uniformity” defect regions identified by EC analyses, demonstrating the use of robot-guided EC for successful defect detection in C-SMC structures.
11 August 2022 in Plastics, Rubber and Composites: Macromolecular Engineering
A main challenge in design with long discontinuous fibre-based sheet moulding compound (SMC) is to understand flow-induced fibre orientation in the part. There are very few experimental methods for characterising the fibre orientation distribution in carbon fibre SMC. Consequently, even though process simulation models for predicting fibre orientation have been developed, the confidence in using these models remains low. This research aims to study the fibre orientation distribution in compression moulded carbon fibre SMC using a combined experimental and numerical approach. A recently developed micro-CT scanning-based method will be adopted to study carbon fibre SMC samples of various sizes. The data collected from the experimental study will be used to assess the predictive validity of selected commercial process simulation packages.