Starches rich in amylose are promising functional ingredients for calory-reduced foods. In this research, a high-amylose Japonica rice starch (amylose content 33.3%) was esterified with octenyl succinic anhydride (OSA) to improve the functional properties. The OSA-modified derivatives were evaluated for structure and functional properties, with OSA-modified normal Japonica rice starch (amylose content 18.8%) used as control. Fourier transform infrared spectra confirmed the introduction of OSA groups to starch. OSA modification made little change to morphology and particle size of high-amylose starch, but decreased the relative crystallinity and pasting temperature and increased the pasting viscosity, swelling power, emulsifying stability, and resistant starch (RS) content. The changes of properties were related to the degree of substitution (DS). Typically, OSA-modified high-amylose starch at DS of 0.0285 shows polyhedral-shape granules, with a volume-average particle diameter of 8.87 μm, peak viscosity of 5730 cp, and RS content of 35.45%. OSA-modified high-amylose starch had greater peak viscosity and RS content and lower swelling power than OSA-modified normal starch of similar DS, but the two kinds of derivatives did not have a significant difference in emulsifying stability. The OSA-modified high-amylose Japonica rice starch could be used as an emulsifier, thickener, and fat replacer in food systems.

The abuse of organophosphate pesticides causes serious threats to human health, which threatens approximately 3 million people and leads to more than 2000 deaths each year. Therefore, it is necessary to determine the residue of fenitrothion (FT) in environmental and food samples. Herein, we developed a non-enzymatic electrochemical sensor with differential pulse voltammetry signal output to determine FT in model solutions and spiked samples. Delicately, the sensor was designed based on the fabrication of hydrothermally synthesized titanium-based metal-organic frameworks (MOFs) material (NH₂-MIL-125(Ti))/reduced graphene oxide (RGO) (NH₂-MIL-125(Ti)/RGO) nanocomposites for better target enrichment and electron transfer. The peak response of differential pulse voltammetry for FT under optimized conditions was linear in the range of 0.072–18 μM with the logarithm of concentrations, and the detection limit was 0.0338 μM. The fabricated sensor also demonstrated high stability and reproducibility. Moreover, it exhibited excellent sensing performances for FT in spiked agricultural products. The convenient fabrication method of NH₂-MIL-125(Ti)/RGO opens up a new approach for the rational design of non-enzymatic detection methods for pesticides.

The mycotoxin deoxynivalenol (DON) is a prevalent contaminant in cereals that threatens the health of both humans and animals and causes economic losses due to crop contamination. The rapid and sensitive detection of DON is essential for food safety. Herein, a colorimetric biosensor based on horseradish peroxidase- and gold nanoparticle-encapsulated zeolitic imidazolate framework-8 (HRP&Au@ZIF-8) was developed for the sensitive screening of DON. The synthesized HRP&Au@ZIF-8 probes not only held great potential for signal amplification but also exhibited stable catalytic activity even under extreme conditions, which endowed the biosensor with both good sensitivity and stability. Under the optimized conditions, qualitative measurement of DON can be achieved through visual inspection, and quantitative evaluation can be performed via absorbance measurements at a characteristic wavelength of 450 nm. The proposed method has demonstrated high sensitivity with a linear detection range of 1–200 ng/mL and a detection limit of 0.5068 ng/mL. It also presented good selectivity and reliability. Furthermore, DON in spiked cereal samples has been quantified successfully using this method. This novel approach demonstrates significant potential for the facile and expeditious detection of DON in cereal products and brings us one step closer to enhancing food safety.

In actual storage processes of rice, environment temperatures fluctuate rather than remain constant. Accumulated temperature is the sum of temperature during the storage period. In this research, six different temperature-varied conditions with two accumulated temperatures (low intensity: 7200°C⸱d; high intensity: 9000°C⸱d) were designed to store rice for 12 months and the stored rice samples were compared in quality. Three low-accumulated temperature conditions were set as follows: No. 4–15°C for 6 months followed by 25°C; No. 5–25°C for 6 months followed by 15°C; No. 8-alternating between 15°C and 25°C every 2 months. Similarly, three high-intensity conditions, No. 6, No. 7, and No. 9, were set with a temperature change from 25°C to 35°C. Three constant temperature conditions, No. 1, No. 2, and No. 3, with storage temperature of 15, 25, and 35°C, respectively, were used as controls. Under temperature-varied conditions, rice demonstrated a decline in germination rate (GR), catalase (CAT) and peroxidase (POD) activities, and an increase in fatty acid value (FAV) as storage time increased. After storage, rice exhibited higher water absorption rate (WAR) and volume expansion rate (VER), but reduced stickiness and sensory scores for appearance, taste and overall quality. Generally, three batches at high-accumulated temperature conditions had lower GR and sensory scores, and higher FAV, WAR, and VER compared to those under low-intensity conditions. Furthermore, variations in the sequence of temperature also affected quality parameters, even at the same accumulated temperature. These findings indicate that under temperature-varied conditions, increased accumulated temperature exacerbates rice deterioration, and different temperature sequences can influence quality at a given accumulated temperature.

Overozonized wheat flour was added to unozonized wheat flour at three different ratios (M1: 1 : 1; M2: 1 : 2; and M3: 1 : 3), and the mixed flour was evaluated for quality properties, including pH, protein component, dough property, pasting property, and steamed bread quality. The pH of the mixed flour gradually increased as the addition content of overozonized flour decreased. The three mixed flour had higher insoluble polymeric protein (IPP) content than unozonized flour. Compared with overozonized flour, M1 and M2 flour did not show a significant difference in IPP content, but M3 flour exhibited a decreased IPP content. Three mixed flour had higher dough development time and dough stability time than both unozonized and overozonized flour, and there was no significant difference among three mixed flour in these two dough parameters. Peak, trough, and final viscosities of the three mixed flour were between those of unozonized and overozonized flour. Steamed bread of three mixed flour had larger specific volume and better texture than that of overozonized flour, with steamed bread of M3 flour showing the best attributes. Among the three mixed flour, M1 flour was the closest to overozonized flour in volatile compounds of steamed bread. These results suggested overozonized flour can be mixed with unozonized flour to decrease the deterioration of overozonization on the dough and food-making properties of wheat flour, but the mixing ratio should be taken into consideration to obtain a better quality.