Phase sensitive optical time domain reflectometry (OTDR) has been widely used in the precise acquisition of the vibration signal along the sensing optical fiber, and has attracted more and more interest. However, polarization fading and coherent fading usually lead to the phase hopping of the recovered signal, thus it is difficult to realize the continuous measurement of vibration, especially the low frequency vibration. The polarization diversity and multi-frequency detection schemes which are usually used to solve the above problems need additional hardware, thus increasing the cost and complexity of the system. In this paper, we propose a statistical method based on nearest neighbor analysis. For each interrogation fiber separation, the phases of the sub-separations are evaluated and selected to reconstruct the vibration. In the experiment, the vibrations with frequencies as low as 0.2 Hz are loaded on the fiber and recovered. The results show that the method can effectively suppress the phase hopping, correct distorted vibration and improve the performance of low frequency vibration measurement of OTDR system on the basis of only numerical calculation.
1 August 2018 in Sensors and Actuators A: Physical
We proposed and experimentally demonstrated a new scheme for enhancing the sensitivity of a fiber laser sensor using Brillouin slow light. The Brillouin laser was exposed to environmental vibrations, producing fluctuations at 408 kHz frequency, which were then interrogated using a Mach–Zehnder interferometer. By introducing Brillouin slow light into one arm of the interferometer, the sensitivity increased by 1.57 times that of a device without slow light. We believe this scheme may provide a new way of using Brillouin slow light and that it has some important implications regarding the use of fiber sensors for measuring the vibration, temperature, strain and so on.
Fiber-optic Cherenkov radiation (FOCR) is a promising nonlinear process that is widely used for nonlinear wavelength conversion. In this study, an all-fiber 920-nm femtosecond pulse source is experimentally demonstrated by using Cherenkov radiation. The 4-nJ 150-fs 1550-nm amplified seed pulse source ensures highly efficient 920-nm pulse generation. Cherenkov radiation is stimulated by inputting the high-energy ultrashort pulse to a highly nonlinear fiber. The dispersion values of the highly nonlinear fiber (HNLF) are carefully chosen to generate CR pulses at 920 nm. The generated pulse has a 150-pJ single pulse energy and a 232-fs pulse duration. The typical 30-nm bandwidth can support a sub-50-fs transform-limited pulse duration. The pump current can be adjusted to tune the central wavelength of the pulse source over 905-930 nm. This very simple approach can generate 920-nm femtosecond pulses. The wavelength range is useful for a wide range of applications, such as two-photon microscopy (TPM) in bio-imaging and so on.
The optical spectrum of mode-locked lasers can exhibit multiple peaks resulting from different mechanisms such as modulation instability, dispersive waves (DWs), and coupling between continuous waves (CWs) and DWs. The latter was recently reported in a mode-locked fiber laser. Here we show that besides the coupling between single-wavelength CW and DWs, dual-wavelength CWs can also couple with DWs giving rise to quite different spectral peaks in a mode-locked fiber laser. In particular, we find that the sidebands of one CW can couple with the other CW, leading to an enhancement of the CWs.
The phase induced intensity noise (PIIN) may seriously reduce the signal-to-noise ratio (SNR) of continuous-wave coherent Doppler lidar (CW-CDL), thereby limiting its performance in practical applications. In this paper, we propose to use optical frequency domain reflectometry (OFDR) technique to locate the PIIN sources and evaluate their intensities. According to the OFDR information, we demonstrate that the PIIN in our CW-CDL system is mainly induced by the crosstalk of polarization beam splitter. Then, the PIIN is reduced by setting fiber delay line, polarization control, and AR-coating. Finally, a wind Doppler signal at a distance of 80 meters is obtained on a clear day, and a typical SNR of 19.4 dB is achieved.