We demonstrate (and are the first to do so) 63 km Brillouin Optical Frequency-Domain Analysis (BOFDA) for temperature and strain monitoring using a 100 km fiber loop. The use of BOFDA for long-range applications can be considered a novel approach, as previous investigations focused on the utilization of Brillouin Optical Time-Domain Reflectometry and Analysis (BOTDR and BOTDA, respectively). At 51.7 km, a 100 m hotspot (37 C) was detected without using distributed Raman amplification or image processing.
We present, to our knowledge for the first time, a 100-km Brillouin Optical Frequency-Domain Analysis (BOFDA) employing a 200-km fiber loop. Compared to our previous publication, enhanced sensor length, sensor accuracy and spatial resolution are presented. The performance improvements are achieved by applying distributed Raman amplification (DRA) and a digital high-pass filter. We report on temperature measurements over sensing distances of 75 km and 100 km both with a 12.5-m spatial resolution. Temperature changes of 5 C have been measured along 75 km sensing fiber. A temperature change of 30 C has been detected at 99.5 km.
This paper addresses the power reduction concepts of an electro-optical transmitter applicable for future small form factor modules such as CFP4. To satisfy the power restrictions of these standards, equations and detailed explanations of the relevant shares of overall power consumption are given. To improve the overall efficiency, an open collector driver realized in a SiGe technology with fT = 190 GHz and fmax = 200 GHz is proposed for driving an InP-based IQ MZ-modulator. This approach saves 30 % of the driver power and achieves an EVMrms of 8.7 % for a QPSK-Signal at 32 GBd. A detailed performance comparison to a structurally identical back terminated driver is presented. Further power reduction is demonstrated with a bias tee configuration for a single modulator. DPSK measurements show a very low power consumption of 290 mW at an EVMrms of 7.5 %. The presented bias tee solution simplifies the assembly without performance compromises. All drivers presented in this paper have differential input/output signals and were designed for a non 50 Ohm output impedance to optimize power consumption and performance.