A gel can be considered to be a two-phase (liquid and solid) system, which lacks flow once it reaches a stationary state. The solid phase is usually a tridimensional polymeric mesh, while the liquid phase is usually found in three forms: contained in great cavities, retained in the capillary pores between micelles, or adsorbed on the surface of a micelle. The influence of the use of gels in crystal growth is diverse and depends on the type of gel being used. A decrease in solubility of any solute in the liquid may occur if the solvent interacts extensively with the polymeric section, hence, the nucleation in gels in these cases apparently occurs at relatively low supersaturations. However, if the pore size is small enough, there is a possibility that a higher supersaturation is needed, due to the compartmentalization of solvents. Finally, this may also represent an effect in the diffusion of substances. This review is divided into three main parts; the first evaluates the theory and practice used for the obtainment of polymorphs. The second part describes the use of gels into crystallogenesis of different substances. The last part is related to the particularities of protein crystal polymorphism, as well as modern trends in gel growth for high-resolution X-ray crystallography.
Electric fields have been employed to promote macromolecular crystallization for several decades. Although crystals grown in electric fields seem to present higher diffraction quality, these methods are not widespread. For most configurations, electrodes are in direct contact with the protein solution. Here, we propose a configuration that can be easily extended to standard crystallization methods for which the electrodes are not in direct contact with the protein solution. Furthermore, the proposed electrode configuration supplies an external DC electric field. Glucose Isomerase from Streptomycesrubiginosus crystals were grown at room temperature using the microbatch method in the presence of 1, 2, 4, and 6 kV. Several crystallization trials were carried out for reproducibility and statistical analysis purposes. The comparison with crystals grown in the absence of electric fields showed that crystallization in the presence of electric fields increases the size of crystals, while decreasing the number of nucleations. X-ray diffraction analysis of the crystals showed that those grown in the presence of electric fields are of higher crystal quality.
The magnetic properties of Fe3Pt compound depend on the degree of disorder present in the system. We have compared a cold‐rolled, disordered sample with a heat treated, ordered sample using circularly polarized synchrotron radiation at the Fe K (7112 eV) and at the Pt L3 (11 564 eV) absorption edge, as well as by Mossbauer spectroscopy, and x‐ray diffraction. Fe–K edge dichroism is compared to the measurements of Faraday rotation using linearly polarized radiation. We found that the magnitude of magnetic dichroism at the Pt L3 edge is reduced when the disordered Fe3Pt is heat treated and ordered. The enhanced sensitivity of the Faraday rotation measurements compared to the magnetic dichroism measurements at the K edges of transition metals are reported on.
2 June 2025 in Acta Crystallographica Section F Structural Biology Communications
Crystal-based structural methods, including X-ray crystallography, are frequently utilized for the determination of high-resolution structures of biomolecules. All crystal-based diffraction methods first require the preparation of biomolecular crystals, and careful sample preparation for crystallization experiments can increase the frequency of success. In this article, strategies to optimize factors that can impact crystallization are presented, from which buffers and reducing agents are most favorable to which crystallization techniques could be used.