Synthetic dyes are widely used in textile, paper, food, cosmetic, and pharmaceutical industries. During industrial processes, some of these dyes are released into the wastewater and their successive release into rivers and lakes produces serious environmental problems. TiO₂ is one of the most widely studied and used photocatalysts for environmental remediation. However, it is mainly active under UV-light irradiation due to its band gap of 3.2 eV, while it shows low efficiency under the visible light spectrum. Regarding the exploration of TiO₂ activation in the visible light region of the total solar spectrum, the incorporation of carbon nanomaterials, such as graphene, in order to form carbon-TiO₂ composites is a promising area. Graphene, in fact, has a large surface area which makes it a good adsorbent for organic pollutants removal through the combination of electrostatic attraction and π-π interaction. Furthermore, it has a high electron mobility and therefore it reduces the electron-hole pair recombination, improving the photocatalytic activity of the semiconductor. In recent years, there was an increasing interest in the preparation of graphene-based TiO₂ photocatalysts. The present short review describes the recent advances in TiO₂ photocatalyst coupling with graphene materials with the aim of extending the light absorption of TiO₂ from UV wavelengths into the visible region, focusing on recent progress in the design and applications in the photocatalytic degradation of synthetic dyes.

In this study, a green and facile thermal reduction of graphene oxide using an eco-friendly system of d-(+)-glucose and NH₄OH for the preparation of reduced graphene oxide was described. The obtained reduced graphene oxide dispersion was characterized by SEM, Dynamic Light Scattering, Raman and X-Ray Photoelectron Spectroscopy. TiO₂ nanoparticles and reduced graphene oxide nanocomposites were successively prepared and used in the preparation of heterogeneous photocatalysts that were characterized by Atomic Force Microscopy and Photoluminescence Spectroscopy and subsequently tested as visible light photocatalysts for the photodegradation of Alizarin Red S in water as target pollutant. Obtained results of photocatalytic tests regarding the visible light photocatalytic degradation of Alizarin Red S demonstrated that the use of reduced graphene oxide in combination with TiO₂ led to a significant improvement for both adsorption of Alizarin Red S on the catalyst surface and photodegradation efficiencies when compared to those obtained with not doped TiO₂.

The effect of surface modification using ascorbic acid as a surface modifier of nano-TiO₂ heterogeneous photocatalyst was studied. The preparation of supported photocatalyst was made by a specific paste containing ascorbic acid modified TiO₂ nanoparticles used to cover Polypropylene as a support material. The obtained heterogeneous photocatalyst was thoroughly characterized (scanning electron microscope (SEM), RAMAN, X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), photoluminescence (PL), and Diffuse Reflectance Spectra (DRS) and successfully applied in the visible light photodegradation of Alizarin Red S in water solutions. In particular, this new supported TiO₂ photocatalyst showed a change in the adsorption mechanism of dye with respect to that of only TiO₂ due to the surface properties. In addition, an improvement of photocatalytic performances in the visible light photodegration was obtained, showing a strict correlation between efficiency and energy band gap values, evidencing the favorable surface modification of TiO₂ nanoparticles.

The use of Polypropylene as support material for nano-TiO₂photocatalyst in the photodegradation of Alizarin Red S in water solutions under the action of visible light was investigated. The optimization of TiO₂pastes preparation using two commercial TiO₂, Aeroxide P-25 and Anatase, was performed and a green low-cost dip-coating procedure was developed. Scanning electron microscopy, Atomic Force Microscopy and X-Ray Diffraction analysis were used in order to obtain morphological and structural information of as-prepared TiO₂on support material. Equilibrium and kinetics aspects in the adsorption and successive photodegradation of Alizarin Red S, as reference dye, are described using polypropylene-TiO₂films in the Visible/TiO₂/water reactor showing efficient dyes degradation.