Polymer composites play a vital role in structural applications enhancing the commercial aspects of less weight and high strength, sufficient ductility, hardness, brittleness and toughness. The desirable properties of these lightweight structures’ form a favourable group while selecting materials recommending for applications. Adding to this the polymer matrix composites reinforced with fibers enhance excellent mechanical properties by adding filler particles into the matrix, unlike unfilled fiber reinforced plastic structures, filler composites exhibit superior bending and tensile strength. The process of developing filler composites is done by adding a minor amount of filler particulates in different percentage with respect to the volume of the matrix by employing the suitable technique. The present work highlights the importance of E-waste rubber which is directly obtained from waste tires which are powdered and sewed. The particle size is limited to 150μm which is then mixed to the matrix and cured the samples followed by adding filler witha smaller percentage which is increased gradually say 5%, 10%, 15% by weight of the matrix considered. The samples were prepared by hand lay-up technique; the prepared samples were cut and tested as according tothe ASTM standard. Tests have been carried out to assess the mechanical behaviour of prepared samples using digital UTM. It is concluded that samples containing 5% filler withstand maximum tensile strength. There is a 25% increase in tensile strength is observed for these samples as compared to unfilled composites. It is also noticed that the samples loaded with 5% filler shows approximately 18.75% increase in bearing bending load when compared to unfilled composite samples. This is due to the strong opposition by particulate filler to matrix de-bonding fromfiber against applied bending load resulting from the uniform dispersion rubber particles when it is loaded with the least percentage.
In India, the utilization of natural fibers for developing new composites with desirable properties has been increasing from the last decade. Bio-waste such as fish scale and coconut shell (CS) powder was utilized to develop natural fiber-based composites in the present work. Three composite specimens, i.e., 30 wt% fish scale (FS), 30 wt% CS powder (CS), and 5 wt% fish scale (FS)+ 5 wt% CS powder specimen, were developed. The tensile, flexural, and impact strength testing was carried out on each specimen. A comparative study was drawn between the test results of the specimen. The experimental results showed that the CS powder-based composites yield improved mechanical properties compared to the fish scale-based composites. Furthermore, a quadratic and cubic mathematical model was developed on the experimental results of tensile and flexural testing for each specimen. The regression results show that the cubic regression model yields better prediction results than the quadratic regression model for all the composite specimens. The experimental results showed that the largely available fish scale and CS powder could be used to produce biowaste-based value-added material that provides a sustainable and eco-friendly approach.
In India, research on the development of new composite materials is extensively increased. In the present study, composites are developed with the renewable materials of plant and animal-based natural fibers. The present study will lead to the experimental and statistical investigation of the composite produced with a combination of plant-based natural fibers, i.e., jute and coco peat powder with the animal-based natural fibers, i.e., silk. In the present study, jute and silk were utilized as reinforcement material, cocopeat powder as a filler material (5%), and epoxy resin as matrix material (35%). The composites were prepared with the varying composition of reinforcement material, and also the filler and matrix material were kept constant. Furthermore, mechanical properties such as tensile, flexural, and impact tests were performed on the developed composites. Further, a comparative study was drawn on the mechanical test results of tensile and flexural strength of the composite using power and polynomial regression model. The regression coefficient (R2) was used to study the correlation between the experimental and predicted values. The results showed that the polynomial regression is the best suitable mathematical model than the power regression model for predicting the composites’ tensile and flexural test performance.