Ceramic supports from bentonite have become a hot research topic because of their low cost and abundance in many countries. This article describes the development and the characterization of a microfiltration support elaborated using an extrusion method followed by sintering at different temperatures (950, 1000, and 1100 °C). X-ray fluorescence, X-ray diffraction, Fourier transform infrared, scanning electron microscopy, transmission electron microscopy, and differential thermal analysis were used for the characterization of the raw material. The resulting support was characterized by scanning electron microscopy, mechanical and chemical resistance, and water permeability. Each tube was 150 mm in length, with an external diameter of 8 mm and an internal diameter of 5 mm.
A photo-Fenton process using a local iron oxide as a natural catalyst was compared to Fenton and UV/H2O2 advanced oxidation processes for degrading crystal violet (CV) dye in aqueous solutions. The catalyst was characterized by transmission electron microscopy (TEM), energy dispersive X-ray microanalysis (EDX), Fourier transform infrared spectroscopy (FT-IR), Raman spectrum, X-ray diffraction (XRD), UV-vis spectroscopy, and Brunauer–Emmett–Teller (BET) analysis. The optical properties proved that the catalyst represents a good candidate for photocatalytic activity. The impact of different parameters (catalyst dose, initial CV concentration, initial H2O2 concentration, pH) on the photo-Fenton efficiency was evaluated. A photo-Fenton process operated under UVC light irradiation, at spontaneous pH, with 1.0 g/L of catalyst and 30 mg/L of H2O2 was the most effective process, resulting in 98% CV dye removal within 3 h. LC-MS and ion-chromatography techniques were used to identify demethylated organic intermediates during the process. Furthermore, a regeneration study of the catalyst showed its stability and reusability (after three treatment cycles, CV dye degradation decreased from 94% to 83%). Finally, the photo-Fenton process was tested in the treatment of real textile wastewater, and the effluent was found to be in compliance with standards for industrial wastewater disposal into sewerage.