The rotary tool is a recent innovation of PMEDM. Aluminium oxide (Al2O3) powder with a particle concentration of 0.5–1.5 gm/l was added into the dielectric to study improved machining performance. Inconel 718 was machined using copper–tungsten electrode with tool rotation about 300 rpm. Experiments were designed using Taguchi’s three-level L18 orthogonal array. A mathematical model is developed to correlate the influences of these variables such as Peak current (Ip), Sparking gap (V), Pulse on time, (Ton), duty cycle and slurry concentration on MRR. A mean effect plots are generated to develop correlation between the influences of these variables such as Material Removal Rate, Tool Wear Rate, Surface Roughness and Heat affected zone. Recast layer affect means by Scanning Electron Microscopy (SEM).
29 May 2023 in International Journal of Thermofluids
Future space missions will have larger telescopes in order to look deeper into space while improvising on spatial resolution.\ud The primary mirrors for these telescopes will be so large that using a monolithic mirror will be nearly impossible because\ud of the difficulties associated with its fabrication, transportation, and installation on a launch vehicle. The feasibility of\ud launching these huge mirrors is limited because of their small launch fairing diameter. The aerodynamic shape of the\ud fairing requires a small diameter, but the height of the launch vehicle, which is available for designers to utilize, is larger\ud than the fairing diameter. This paper presents the development of an axial deployment mechanism based on the screw jack\ud principle. The mechanism was designed and developed, and a prototype was constructed in order to demonstrate a lab\ud model
Additive manufacturing (AM) is a layered manufacturing technique. It can produce parts/printing layer by layer. When the deposition process involves a number of process parameters such as temperature gradients, build orientation, raster width, raster angle, layer thickness, and disposition pattern, etc. This overview considers the various aspects of the process parameter that influence the part quality and generate residual stresses in the Fused deposit Modelling (FDM) component. This process, parameters influenced the surface finish quality of parts and warpage.
Dear Editor, I hope you are doing well. I have reviewed the article titled "Heat Transfer in Composite Materials: Mechanisms and Applications." The review article discusses the different applications of heat transfer composite materials, includin...