Small and medium enterprise (SME) manufacturers are impeded from participating in sustainability initiatives using new technologies due to the high cost and the lack of clarity on where to start. The integration of low-cost digital solutions has enabled SME manufacturers to adopt Industry 4.0 technologies to support operations. However, using low-cost technologies to address sustainability challenges is underexplored. This article addresses three key research questions: What digital solutions do SMEs need to address industrial sustainability challenges? To what extent can existing low-cost digital solutions be used to address industrial sustainability challenges? How should new digital solutions for developing greater sustainability be prioritised? Three main tasks were conducted. Initially, a new sustainability-focused sub-catalogue was created using an existing catalogue of low-cost solution areas for manufacturing. Secondly, a workshop with 17 participants was used to identify the top ten priority solution areas, with process monitoring, energy monitoring, and quality inspection at the top. Lastly, existing low-cost digital solutions within the top ten priority areas were evaluated to identify how they could contribute to lean manufacturing. Predominantly existing solutions could contribute to waste or use reduction in lean manufacturing. This study provides a foundation for the future development of low-cost solutions for sustainability by indicating manufacturers’ key priority areas and outlining how existing solutions could be adapted to support waste reduction.
There are many well-known systematic approaches to design the digital systems used in manufacturing. However, there are only a few approaches that specifically deal with low-cost components. Such components may not provide the same level of completeness as more expensive industrial alternatives and may need to be combined with other components to become comparable. Consequently, common design challenges for systems comprising such low-cost components revolve around extendability and interface standardisation. There is a need for analysing the capability of the existing approaches to design these systems. This study aims to evaluate the effectiveness of designs for low-cost digital manufacturing systems that have been derived from a particular design approach. The proposed evaluation methodology is used for the special case of designs that are directly based on reference architectures and for the development of specific metrics for that purpose. To quantify the effectiveness, these metrics are applied to a number of design scenarios. Although focusing on reference-architecture-based designs, the proposed methodology can also be used for other design approaches. The evaluation and structured implementation comparison helps practitioners in selecting an effective design approach to low-cost digital manufacturing systems and provides insights into how a particular design approach can become more effective.
Demonstrators, testbeds and learning factories enable researchers to investigate important manufacturing challenges and to trial solutions without disrupting industrial production facilities. In this way, solutions and systems can be developed close to a ‘production-ready’ state prior to industrial deployment. This paper reviews demonstrators and testbeds developed for smart manufacturing in the last 20 years. A key observation is that such demonstrators have predominantly focused on emulating single or multiple closely connected operations. Such developments reflect the activities of a single production facility and/or organisation. In contrast, there are few reports on demonstrators which seek to replicate the behaviour and challenges associated with multi-site factories or integration with existing legacy factory systems. To address this gap, a multi-operation demonstrator has been created. The demonstrator aims to replicate coordinated production between multiple small manufacturing sites and provides a testbed to investigate operational challenges. The current demonstrator, the research investigated, and the direction of future research proposed are outlined.