We established three-dimensional quantitative structure-activity relationship (3D QSAR) pharmacophore models of ultraviolet (UV) absorption intensities for phthalic acid esters (PAEs). Substituent positions were obtained using the optimum pharmacophore model, and hydrophobic groups were used to generate PAE derivatives from the priority pollutants. The UV spectra of the PAE derivatives were calculated using the same method, and were used to screen for PAE derivatives with greatly enhanced UV absorption intensities. The derivatization and solvation effects on identification of PAEs and derivatives were considered. The results showed that the Hypo1 pharmacophore model had good predictive abilities and there were 14 PAE derivatives generated. The maximum UV absorption intensities of three PAE derivatives were 121.85%, 105.20%, and 191.11% respectively, higher than those of the corresponding original PAEs. Analysis of the solvation effect showed that the UV peaks red shifted, and the degree of red shift increased with increasing solvent polarity. The minimum differential wave numbers of the UV peaks after PAE derivatization and solvation were higher than the minimum resolution of the UV spectrometer (0.1 nm). A two-dimensional QSAR analysis of the enhancement mechanism can reveal the derivatization and solvation enhancement. The logKow values of DNOP derivatives were predicted to lower by 25.55%-34.12%.
24 April 2024 in Polish Journal of Environmental Studies
In this study, emulsion and mine water samples were collected from the Daliuta area, and the emulsion composition was analyzed. The typical pollutants in the emulsion were triethanolamine, sodium benzoate, sodium nitrite, and sodium hyponitrotriacetate. Furthermore, migration and transformation studies were conducted with respect to these typical pollutants in the emulsion. When the mine water was passed through the aeration zone of a water accumulation leaching device, the pollutant concentrations considerably decreased, resulting in significant adsorption and migration effects. Subsequently, the adsorption effect was significantly reduced. The adsorption rate of sodium benzoate and sodium hyponitrotriacetate increased with an increase in the emulsion concentration on the 30th day. The adsorption rate of sodium nitrite in 1 L mine water with 20 mL emulsion on the 30th day was 86.4%. The noncarcinogenic health risk assessment and exposure index (EI) model calculations of the simulated mine water containing emulsion revealed that all the hazard quotient (HQ) and EI values of carcinogens were >1. Furthermore, reference pollutant concentrations under the specific conditions of HQ and EI were obtained. These study findings are expected to provide scientific data support for local governments to strengthen geological environment management in mining areas.
The composition of emulsion is complex. In the process of coal mining, the emulsion required by the hydraulic equipment can enter the mine water through a variety of channels, thereby affecting the water quality of the mine. In this study, the mine water of a super large coal mine, Daliuta Coal Mine, was collected, and static and dynamic simulation tests were designed to analyze the changes in various water quality indicators of mine water containing different concentrations of emulsions over time. Furthermore, the health risk assessment model was applied to evaluate the health risks of hexavalent chromium (Cr6+) and chloride in mine water containing emulsions on different populations. The results indicate that the alkaline substances such as sodium castor oil in the emulsion can increase the pH value of mine water, but it is more obvious when the emulsion concentration is high. The mine water itself contains chloride and sulfate exceeding 300 and 400 mg/L, respectively, and the addition of emulsion under static conditions has little effect on them, while the amount of emulsion added under dynamic conditions reaches 20 mL/L, which has a significant impact. The emulsion contains a certain amount of Cr6+ and can affect the total dissolved solid content, total hardness, and other indicators of mine water through mechanisms such as adsorption, solubilization, and chemical precipitation. The calculation results of the health risk assessment model indicate that the excessive chloride in the mine water in the area poses a potential non-carcinogenic risk to all populations exposed to their environment. The health risk index of Cr6+ increases with the increase in emulsion content in mine water, and the potential non-carcinogenic risk is higher for children. Overall, emulsions can significantly deteriorate the quality of mine water. This research can provide a scientific theoretical basis for subsequent study of mine water pollutant treatment, water quality monitoring and management, and health risk assessment, thereby contributing to reducing the health risks it brings and protecting the safety of local groundwater quality.