Pickled mustard tuber (PMT), also known as Brassica juncea var. tumida, is a conical tuberous vegetable with a scaly upper part and a coarse fiber skin covering the lower part. Due to its highly distorted and complex heterogeneous fiber network structure, traditional manual labor is still used for peeling and removing fibers from pickled mustard tuber, as there is currently no effective, fully automated method or equipment available. In this study, we designed an underactuated humanoid pickled mustard tuber peeling robot based on variable configuration constraints that emulate the human “insert-clamp-tear” process via probabilistic statistical design. Based on actual pickled mustard tuber morphological cluster analysis and statistical features, we constructed three different types of pickled mustard tuber peeling tool spectral profiles and analyzed the modular mechanical properties of three different tool configurations to optimize the variable configuration constraint effect and improve the robot’s end effector trajectory. Finally, an ADAMS virtual prototype model of the pickled mustard tuber peeling robot was established, and simulation analysis of the “insert-clamp-tear” process was performed based on the three pickled mustard tuber statistical classification selection. The results showed that the pickled mustard tuber peeling robot had a meat loss rate of no more than 15% for each corresponding category of pickled mustard tuber, a theoretical peeling rate of up to 15 pieces per minute, and an average residual rate of only about 2% for old fibers. Based on reasonable meat loss, the efficiency of peeling was greatly improved, which laid the theoretical foundation for fully automated pickled mustard tuber peeling.
Mg-Cu bimetallic materials have been widely studied because of their low density, good electrical conductivity, and excellent hydrogen storage properties. However, the interface bonding strength of Mg/Cu is low. In this study, we examined the effect of hot-dip tin coating (HDTC) with copper (Cu) on the interfacial metallurgical bonds between AZ91D Magnesium (Mg) alloy and Cu composite casting. A transition layer composed of Mg2Cu and MgCu2 intermetallic compounds (IMCs) formed at the interface of the AZ91D/HDTC-Cu composite casting. However, the transition layer was about 1 μm at the AZ91D/Cu interface, mainly comprising Mg(Al, Cu)2 IMC. Both the AZ91D/Cu and AZ91D/HDTC-Cu interfaces exhibited many labyrinthine Mg(Al, Cu)2 IMCs and layer-like Mg2(Al, Cu) IMCs. Moreover, the interfacial shear strength of the AZ91D/Cu was changed from 12.6 MPa to 52.4 MPa due to the solid solution of Sn atom and the precipitation of Mg2Sn IMC at the interface after HDTC treatment. Meanwhile, the shear fracture surfaces are characterized by brittle fractures.
Graphene-based resistive sensors exhibit excellent sensing performance, but face challenges in terms of uniformity, stability, and large-scale fabrication. To address these issues, in this study, we blade-coated a PI/PDMS precursor on the fabric surface and constructed graphene via in situ laser induction, thereby effectively improving the preparation efficiency and stability of graphene. Meanwhile, the influence of the PI-to-PDMS ratio on the performance of the laser-induced graphene resistive sensor was investigated. It was found that at a PI-to-PDMS ratio of 1:3, the formed graphene showed the fewest defects and the highest graphene proportion, which originated from its good fluidity, compatibility, and crosslinking density. Experimental results demonstrate that the sensor exhibits favorable sensing performance, with a linearity of 0.99 and a sensitivity of 8.64 within the 10–20% strain range of Sample 2, along with repeatable stability over 2000 cycles, meeting the requirements of skin-friendly contact and highly stable motion monitoring for human joints. This study provides a reference for the efficient and rapid construction of graphene-based resistive sensors and shows considerable application potential.