Graphene’s featureless optical absorption, ultrahigh carrier mobility, and variable optical absorption by an applied gate voltage enable a new breed of optical modulators with broad optical and electrical bandwidths. Here we report on an electro-optic modulator that integrates single-layer graphene in a sub-wavelength thick, reflective modulator structure. These modulators provide a large degree of design freedom, which allows tailoring of their optical properties to specific needs. Current devices feature an active aperture ~100 µm, and provide uniform modulation with flat frequency response from 1 Hz to >100 MHz. These novel, low insertion-loss graphene-based modulators offer solutions to a variety of high-speed amplitude modulation tasks that require optical amplitude modulation without phase distortions, a flat frequency response, or ultra-thin geometries, such as for controlling monolithic, high-repetition rate mode-locked lasers or active interferometers.
Intracavity loss modulation enables offset-frequency control with bandwidths beyond what is possible by pump power modulation. To demonstrate this new method, we use a subwavelength thick graphene electro-optic modulator to stabilize the offset frequency in a Tm:fiber frequency comb at 1.95 μm wavelength. Record-low residual phase noise of 144 mrads was achieved with this new locking scheme.
Surface enhanced Raman spectroscopy (SERS) is a novel method to sense molecular and lattice vibrations at a high sensitivity. Although nanostructured silver surface provides intense SERS signals, the silver surface is unstable under acidic environment and heated environment. Graphene, a single atomic carbon layer, has a prominent stability for chemical agents, and its honeycomb lattice completely prevents the penetration of small molecules. Here, we fabricated a SERS substrate by combining nanostructured silver surface and single-crystal monolayer graphene (G-SERS), and focused on its chemical stability. The G-SERS substrate showed SERS even in concentrated hydrochloric acid (35–37%) and heated air up to 400 °C, which is hardly obtainable by normal silver SERS substrates. The chemically stable G-SERS substrate posesses a practical and feasible application, and its high chemical stability provides a new type of SERS technique such as molecular detections at high temperatures or in extreme acidic conditions.