Five typical in-use city buses in Tangshan with different emission standards, fuel power types, and emission control technology routes were selected as the research objects. PEMSs (Portable Emissions Measurement Systems) and OBD (On-Board Diagnostic) remote monitoring technologies were used to conduct research on actual road conditions and emission characteristics. The research aimed to analyze the driving characteristics of different power types of bus engines and after-treatment systems, as well as their impact on emissions. The results indicated that the actual road driving is mainly in the urban and suburban areas of the local region. Additionally, the VSP (Vehicle Specific Power) was found to be distributed in the low- and medium-speed range of mode Bin0~Bin24. The emission rates of each pollutant showed an increasing trend with the increase in VSP. THC and NOx emissions of CNG and LNG buses are significantly higher than those of gas–electric hybrid buses. However, the PM emissions are lower. Therefore, it is necessary to strengthen the NOx emission control of CNG and LNG buses. With the improvement in emission standards and the use of hybrid technology, CO₂ and NOx emissions of China IV buses can be reduced by 13% and 53.5% compared with China III buses of the same tonnage. The CO₂ and NOx emissions of China V buses using natural gas combustion and an electric mixture are 20% and 18.8% lower than those of China V buses of the same tonnage using only natural gas. In the actual operation of the diesel–electric hybrid bus equipped with the SCR (Selective Catalytic Reduction) system, the working time of the engine is about 35.5 ± 5%, and the working time of the SCR system only accounts for 65.5 ± 12%. The low working conditions of the SCR system and the low temperature of SCR system are the reasons for the high NOx concentration at the rear end of the SCR system when the hybrid electric bus is running at low speeds.

Accurately quantifying carbon dioxide (CO₂) emissions from heavy-duty diesel trucks (HDTs) is crucial for developing effective transportation emission reduction strategies. In this study, we adopted a bottom–up approach and, in conjunction with the “International Vehicle Emissions” (IVE) model, constructed a high-resolution 1 × 1 km CO₂ emission inventory for the urban area of Kunming, China. Using data from 1.24 million track points collected from 5996 heavy-duty diesel trucks, we implemented a map matching algorithm based on a simplified hidden Markov model (HMM) to efficiently process large-scale GPS data. Furthermore, we improved upon traditional spatial allocation methods by dynamically integrating track point density with static road network density. The results indicate that although higher driving speeds correspond to lower CO₂ emission rates, heavy-duty diesel trucks typically operate within an observed speed range of 40–60 km/h, with an average emission factor of approximately 500 g/km. Vehicles compliant with the “National III” emission standards remain the primary source of CO₂ emissions in this region. Correlation analysis reveals a significant positive relationship (p < 0.01) between emissions from heavy-duty diesel trucks and both traffic volume and mileage. Notably, daytime vehicle restriction policies led to a temporal redistribution of emissions rather than a net reduction in emissions; this resulted in increased activity levels of heavy-duty diesel trucks at night, leading to a surge in nighttime emissions. In terms of spatial distribution, the “dual-density” allocation method proposed in this study more accurately captured emission hotspots, revealing that CO₂ emissions are primarily concentrated in the southeastern part of the city—a distribution pattern largely influenced by the city’s industrial layout.