A simple approach to enable water-management agencies employing free data to create a single set of water quality predictive equations with satisfactory accuracy is proposed. Multiple regression-derived equations based on surface reflectance, band ratios, and environmental factors as predictor variables for concentrations of Total Suspended Solids (TSS) and Total Nitrogen (TN) were derived using a hybrid forward-selection method that considers both p-value and Variance Inflation Factor (VIF) in the forward-selection process. Landsat TM, ETM+, and OLI/TIRS images were jointly utilized with environmental factors, such as wind speed and water surface temperature, to derive the single set of equations. Through splitting data into calibration and validation groups, the coefficients of determination are 0.73 for TSS calibration and 0.70 for TSS validation, respectively. The coefficients of determination for TN calibration and validation are 0.64 and 0.37, respectively. Among all chosen predictor variables, ratio of reflectance of visible red (Band 3 for Landsat TM and ETM+, or Band 4 for Landsat OLI/TIRS) to visible blue (Band 1 for Landsat TM and ETM+, or Band 2 for Landsat OLI/TIRS) has a strong influence on the predictive power for TSS retrieval. Environmental factors including wind speed, remote sensing-derived water surface temperature, and time difference (in days) between the image acquisition and water sampling were found to be important in water-quality quantity estimation. The hybrid forward-selection method consistently yielded higher validation accuracy than that of the conventional forward-selection approach.
The performance of flow through orifices on a perforated distribution pipe between periods with and without partial clogging (submersion of part of the distribution pipe) was compared. The distribution pipe receives runoff and delivers it to an underground infiltration bed. Clogging appeared in winter but was reduced in summer. Performance of flow delivery was found to be defined by the effective pipe length and the pressure head. ANCOVA (ANalysis of COVAriance) was used to examine the clogging effect with flow rate plotted against the effective pipe length times the square root of the mean pressure head, and found that it was significant during low or no rainfall. During larger storms, clogging had little effect on pipe performance. Clogging might be caused by leaves and other trash accumulating in the lower section of the pipe in winter and its effect was insignificant when the water level rose in the pipe, utilizing significantly more orifices on the distribution pipe. Larger storms might also move the debris, thus exposing the orifices. The current maintenance schedule was sufficient to keep the distribution pipe at a satisfactory performance even though partial clogging can exist.
Hydrologic models such as the USEPA Stormwater Management Model (SWMM) are commonly used to assess the design and performance of green infrastructure (GI). To accurately represent GI performance models used in design need to be able to address both the hydrology/hydraulics of the catchment and the GI unsaturated (vadose) zone hydrology. While hydrologic models, such as SWMM, address the need for catchment hydrology/hydraulics, they often simplify the unsaturated zone hydrology. This paper presents a methodology utilizing existing components of SWMM to represent unsaturated zone hydrology in an accessible format that does not require adjustments to the SWMM source code. The methodology simulated the unsaturated soil water movement by considering flow caused by differences of soil matric head and flow caused by gravity between soil layers with finite depth/length. The flow flux related to the soil matric head is a function of soil water diffusivity (D) and the soil moisture gradient, where D can be represented by a pump curve in SWMM. The flow flux related to gravity was controlled by unsaturated hydraulic conductivity (K) only and was also simulated by a pump. The methodology was compared to another variably saturated model, HYDRUS, with theoretical soils (with single layers of sand, loam, silt, and clay, as well as dual-layer scenarios). Field data was used to compare the methodology to HYDRUS and the SWMM LID (Low Impact Development) module. In all comparisons the presented methodology and HYDRUS delivered similar results for the vadose zone response to a storm event, while the LID module of SWMM exhibited slower water movement. The results showed that under natural conditions, the approximation of the presented methodology yielded satisfactory results to simulate flow through the unsaturated vadose zone.
1 February 2019 in Journal of Irrigation and Drainage Engineering
Popularity of infiltration-based green infrastructure (GI) has spurred concern about rising groundwater tables and the potential detrimental effect on building foundations. This study examines water table fluctuations adjacent to green infrastructure sidewalk planters during two winters (2014–2015 and 2016–2017) in Philadelphia. Groundwater mounding is observed in the latter period but not the former. Due to the proximity to a park, the water table rise is the combined effect from both the GI and the park. For the first winter, the sidewalk planters were not fully vegetated or maintained. It is hypothesized that the increased groundwater mounding in 2016–2017 was from the increased infiltration rate caused by improved vegetation and maintenance. Groundwater mounding was not observed beyond 3 m from the GI except for large storms. Because the water table rise was transient, groundwater mounding had minimal impact beyond 3 m for current GI configurations and soil conditions. The observations conform to prior computer simulations. The results also show that intraseason water table fluctuations are far greater than those created by local infiltration.
Green infrastructure (GI) systems are often overdesigned. This may be a byproduct of static sizing (e.g., accounting for a design storm’s runoff volume but not exfiltration rates) or may be deliberate (e.g., buffering against performance loss through time). In tree trenches and other GI systems that require stormwater to accumulate in an infiltration bed before it contacts the planting medium, overdesign could reduce plant water availability significantly. This study investigated the hydrological dynamics and water relations of an overdesigned tree trench system and identified factors contributing to, compounding, and mitigating the risk of plant stress. Water in the infiltration bed reached soil pits only once in three years, with that event occurring during a hydrant release. Moreover, minimal water was retained in soil pits during the event due to the hydraulic properties of the soil media. Through a growing season, one of the two tree types frequently experienced water stress, while the other did so only rarely. These contrasting responses can likely be attributed to roots being largely confined to the soil pits vs. reaching a deeper water source, respectively. Results of this study demonstrate that, in systems where soil pits are embedded in infiltration beds, overdesign can raise the storm size required for water to reach the soil media, reducing plant water availability between storms, and ultimately inducing physiological stress.