This study conducted experimental and numerical investigations on piezoelectric wafer active sensors (PWASs) bonded to an aluminum plate to assess the impact of bonding degradation on Lamb wave generation. Three surface-bonded PWASs were examined, including one intentionally bonded with a reduced adhesive to create a defective bond. Thermal cyclic aging was applied, monitoring through laser Doppler vibrometry (LDV) and static capacitance measurements. The PWAS with the initially defective bond exhibited the poorest performance over aging cycles, emphasizing the significance of the initial bond condition. As debonding progressed, modifications in electromechanical behavior were observed, leading to a reduction in wave amplitude and distortion of the generated wave field, challenging the validity of existing analytical modeling of wave-tuning curves for perfectly bonded PWASs. Both numerical simulations and experimental observations substantiated this finding. In conclusion, this study highlights the imperative of a high-integrity bond for the proper functioning of a guided wave-based structural health monitoring (SHM) system, emphasizing ongoing challenges in assessing SHM performance.
We present a novel method for in-situ monitoring of the vacuum-bag-only (VBO) consolidation process of CF/LM-PAEK thermoplastic composites using an embedded Fibre Bragg Grating (FBG) sensor. An FBG sensor is first employed to monitor transverse strain in the plane during composite manufacturing. The data obtained from the embedded sensor demonstrate its sensitivity to thermal transitions of the thermoplastic matrix, including glass transition, crystallisation and melting. The coefficient of thermal expansion (CTE) of the composite material is also estimated using the FBG, with results validated by dilatometric measurements. Second, the sensitivity of the embedded FBG to consolidation phenomena, particularly the establishment of intimate contact between adjacent layers is also investigated. FBG-based monitoring of two different laminate configurations, one with raw prepreg plies and the other with pre-crystallised prepreg plies, confirms the sensor’s effectiveness in detecting the onset of intimate contact at the glass transition temperature. These findings highlight the potential of FBG-based monitoring for optimising composites manufacturing and improving quality control of high-performance thermoplastic composites.