Herein, a three-dimensional flower-like cobalt-nickel bimetallic metal-organic framework (CoNi-MOF) coupled with two-dimensional graphene oxide (GO) nanocomposites was successfully synthesized for the selective and simultaneous electrochemical determination of catechol (CC) and hydroquinone (HQ). The three-dimensional flower-like structure of the CoNi-MOF/GO nanocomposite has a multilayer structure and a large surface area, which greatly improves its electrocatalytic activity towards CC and HQ. Differential pulse voltammetry (DPV) results showed that the peak-to-peak separation of CC (0.223 V) and HQ (0.120 V) was 103 mV at a CoNi-MOF/GO modified glassy carbon electrode (CoNi-MOF/GO/GCE), suggesting that the proposed modified electrode can selectively and simultaneously determine them. Under optimal conditions, the CoNi-MOF/GO/GCE showed an excellent analytical performance for the simultaneous determination of CC and HQ, including a wide linear range (0.1–100 μM), low detection limit (0.04 μM for HQ and 0.03 μM for CC) and high anti-interference ability. As expected, the developed modified electrode has been used to analyze CC and HQ in river water, with acceptable results.
Here, a novel method to prepare high performance shear thickening fluids (STFs) by dispersing calcinated silica microspheres into ethylene glycol is reported. The silica particles were prepared by hydrolyzing tetraethylorthosilicate (TEOS), and then they were treated under high temperature to remove the physically adsorbed water and the -OH groups on the surfaces. The influence of the temperature on the rheological properties of the final STFs was investigated and the STF prepared under the optimum temperature exhibited the best ST effects. A possible mechanism was proposed and it was found that a proper solvation layer adsorbed on the silica surface resulted in lower critical shear rate and higher shear thickening viscosity.
LiCoO2 (LCO) can deliver ultrahigh discharge capacities as a cathode material for Li-ion batteries when the charging voltage reaches 4.6 V. However, establishing a stable LCO cathode at a high cut-off voltage is a challenge in terms of bulk and surface structural transformation. O2 release, irreversible structural transformation, and interfacial side reactions cause LCO to experience severe capacity degradation and safety problems. To solve these issues, a strategy of gradient Ta doping is proposed to stabilize LCO against structural degradation. Additionally, Ta1-LCO that was tuned with 1.0 mol% Ta doping demonstrated outstanding cycling stability and rate performance. This effect was explained by the strong Ta-O bonds maintaining the lattice oxygen and the increased interlayer spacing enhancing Li+ conductivity. This work offers a practical method for high-energy Li-ion battery cathode material stabilization through the gradient doping of high-valence elements.
1 July 2019 in International Journal of Electrochemical Science
Five nickel selenides were obtained by regulating the preparation conditions. Ni1−xSe and c-NiSe2 present excellent ORR activity and better durability and methanol tolerance than Pt/C. The ORR process is dominated by a 4-electron pathway.