The insulating liquids used in industrial applications are typically mineral oils. In recent years however, significant attention has been paid to alternative insulating fluids, including synthetic and natural ester liquids. In order to expand their practical applications, it is important to have detailed information on their dielectric properties. In this present paper, the dielectric properties of synthetic ester, Midel 7131; mineral oil, Shell Diala D; and vegetable (rapeseed) oil have been investigated. It has been shown that Midel 7131 has a higher ac breakdown voltage (27.6 kV) as compared with Diala D oil (26.4 kV) and rapeseed oil (24.6 kV). However, the breakdown voltage of the Diala D oil has the smallest standard deviation (7%) amongst the tested liquids (13% for Midel 7131 and 11% for rapeseed oil). Statistical analysis of the breakdown voltages has been conducted and it has been shown that the ac breakdown voltages can be described by a normal distribution. dc I-V characteristics have been measured and the space charge saturation regime has been observed for all three liquids starting from ~9 kV for positive energisation and ~10 kV for negative energisation in the point-plane topology. Apparent mobilities of the charge carriers in the tested liquids have been obtained using I^1/2-V curves; these mobilities can be used for calculation of the space charge influenced distribution of the electric field in liquid insulators stressed with dc voltage. Such analysis can be important for design and exploitation of HVDC power systems.

Objective: This study investigates possible advantages in pulsed over continuous 405-nm light-emitting diode (LED) light for bacterial inactivation and energy efficiency. Background: Alternative nonantibiotic methods of disinfection and infection control have become of significant interest. Recent studies have demonstrated the application of systems using 405-nm LEDs for continuous disinfection of the clinical environment, and also for potential treatment of contaminated wounds. Methods: Liquid suspensions of 10 ³ colony-forming units/mL populations of Staphylococcus aureus were subject to pulsed 405-nm light of different frequencies, duty cycles, and intensities and for different lengths of time. Results: Pulsed exposures with the same average irradiance of 16 mW/cm ² and varying duty cycle (25%, 50%, 75%) showed very similar performance compared with continuous exposures, with 95–98% reduction of S. aureus achieved for all duty cycles. The pulsing frequency was varied in intervals from 100 Hz to 10 kHz and appeared to have little effect on antimicrobial efficacy. However, when comparing pulsed with continuous exposure, an improvement in inactivation per unit optical energy was achieved, with results showing an increase of approximately 83% in optical efficiency. Conclusions: These results suggest that under pulsed conditions, a lower energy consumption and lower perceived brightness could be achieved, thus potentially providing improved operating conditions for medical/infection control applications without compromising antimicrobial efficacy.

This paper explores the possibilities of using impulsive and steady-state corona discharges for biodecontamination operations. A high tension tubular corona electrode was stressed with positive or negative dc voltage with magnitude up to 26 kV, and a grounded mesh was used as an opposite electrode. Different operational regimes of this corona generator were investigated for the production of ozone in air flow and the inactivation of microorganisms. The test microorganisms used in this work were Escherichia coli and Staphylococcus aureus, populations of which were seeded onto agar plates. These bacterial plates were located behind the grounded mesh electrode to assess bactericidal efficacy. The results show that corona discharges have a strong bactericidal effect, for example, positive flashing corona discharges were able to reduce populations of the test microorganism by ~ 94% within a 30-60-s time interval. Negative steady-state corona discharges also produce noticeable bactericidal effect, reducing population of E. coli and S. aureus by more than 97% within a 120-s energization interval. The bactericidal efficiency of different corona discharge modes and its correlation with ozone levels produced by these discharges are discussed. The results obtained in this work will help in the design and development of compact plasma systems for environmental applications.

The impulse dielectric behavior of insulating liquids is of significant interest for researchers and engineers working in the field of design, construction, and operation of pulsed power systems. Analysis of the literature data on transformer oils shows that potentially there are several different physical processes that could be responsible for dielectric breakdown by submicrosecond and microsecond impulses. While for short submicrosecond impulses ionization (plasma streamer) is likely to be the main breakdown mechanism, for longer impulses, the thermal effects associated with Joule heating start to play an important role. This paper provides a theoretical analysis of the latter mechanism in dielectric liquids of different degrees of purity stressed with high-voltage (HV) impulses with duration sufficient to cause local heating, evaporation, and formation of prebreakdown gas bubbles. The proposed model is based on the assumption that dielectric breakdown is developed through percolation channels of gas bubbles, and the criterion of formation of these percolation chains is obtained. To test the developed model, the breakdown field-time characteristics have been calculated for the liquid with chemical composition close to that of transformer oils but with known thermodynamic characteristics (n-hexane). Its dielectric strength has been obtained as a function of externally applied pressure and temperature. The analytical results show good agreement when compared with the experimental data available in the literature.

It has been proven that hydroxyl (OH) radicals can be generated by streamer discharges across water surfaces under ambient atmospheric conditions. Hydroxyl radicals have the highest oxidation capability amongst all oxygen-based reactive species, thus OH play an important role in oxidation of organic molecules and the bactericidal effects of plasma discharges. In this study, generation of hydroxyl radicals in water by pulsed streamer discharges was investigated. Terephthalic acid was used as a chemical probe as this acid is converted into 2-hydroxyterephthalic acid (HTA) by chemical reaction with OH radicals. The concentration of OH radicals was quantified by measuring the fluorescence light intensity generated by HTA molecules in water solutions. Both positive and negative pulsed discharges with different voltage levels were tested. Two different types of sample holder - non-conductive plastic dishes, and dishes lined with conductive aluminum foil - were used in order to investigate the effect of the discharge propagation path on the efficiency of OH production. The efficiency of OH production was measured as a function of: the distance between the needle electrode and the water surface; the magnitude and polarity of HV energization; and the total delivered charge. The obtained results will help in optimization of non-thermal plasma systems for chemical and biological decontamination.