Yves Burkhardt

Yves Burkhardt

Electrical drive systems, Technical University of Darmstadt, Darmstadt, Hesse, Germany

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
19 December 2023 in Lubricants
Verified
Journal Article
Open access
PDF file
Steffen PuchtlerSteffen Puchtler
Steffen Puchtler
RMRobert Maier
Robert Maier
MKMartin Kuhn
Martin Kuhn
YBYves Burkhardt
Yves Burkhardt
The reason for the failure of electric vehicle drives is increasingly current-induced damage to rolling bearings. Studies show that rolling bearings are more susceptible to current pass-through after the first occurrence of unwanted bearing currents. To investigate this effect, a test plan is introduced with variations in axial and radial loads, as well as rotational speeds. A new bearing is mechanically run-in for each test point and then subjected to a realistic voltage signal of gradually increasing amplitude. After the initial breakdown, the different voltage amplitudes are applied again to investigate the behavior after the initial breakdown. During the whole test, the maximum current, the duration and the dissipated energy of each breakdown are measured. The results provide insights into the processes after the initial breakdown and the stochastic nature of the breakdown behavior.

20 March 2025 in arXiv
Verified
Preprint
Open access
PDF file
KMKarsten Müller
Karsten Müller
AWAndreas Wanke
Andreas Wanke
YBYves Burkhardt
Yves Burkhardt
Herbert De GersemHerbert De Gersem
Herbert De Gersem
In this paper, various skewing configurations for a permanent magnet synchronous machine are evaluated by comparing torque ripple amplitudes and tooth forces. Since high-frequency pure tones emitted by an electrical machine significantly impact a vehicle's noise, vibration, and harshness (NVH) behavior, it is crucial to analyze radial forces. These forces are examined and compared across different skewing configurations and angles using the Maxwell stress tensor in 2D and 3D finite-element (FE) simulations. In addition to conventional investigations in 2D FE simulations, 3D FE simulations are executed. These 3D FE simulations show that axial forces occur at the transition points between the magnetic segments of a linear step skewed rotor.



11 March 2026 in IEEE Transactions on Transportation Electrification
Verified
Journal Article
Closed access
TYTadele Lijalem Yirisaw
Tadele Lijalem Yirisaw
ARAndreas Reeh
Andreas Reeh
WBWolfram Birkmayer
Wolfram Birkmayer
YBYves Burkhardt
Yves Burkhardt
A novel fault-tolerant electric drive system concept based on a permanent magnet synchronous machine employing two three-phase systems is introduced. The stator winding uses bifilar tooth coils physically separating serial turns of each coil. Each bifilar coil is supplied by separate inverter module while ensuring the same current direction in the slots and, thus, an additive current linkage. With the aim of fault tolerance, this design prevents the risks of inter-turn short circuits within the same coil. Such faults can cause the most severe local fault currents in a stator winding in case of a single-turn short circuit. The paper investigates effects of short circuits between the neighboring turns of the bifilar coils for two system configurations as well as different detection methods by means of finite element analysis in conjunction with field oriented control. Evaluations of the three-phase sum currents, the phase leakage currents, and the phase current spectrum during turn-to-turn faults enable early-stage detection when the fault resistance is still high.

23 March 2026 in e+i Elektrotechnik und Informationstechnik
Verified
Journal Article
Closed access
PDF file
KMKarsten Müller
Karsten Müller
AWAndreas Wanke
Andreas Wanke
Herbert De GersemHerbert De Gersem
Herbert De Gersem
YBYves Burkhardt
Yves Burkhardt