Unidirectional (UD) fiber-reinforced thermoplastic tapes provide excellent specific mechanical properties; thus, they are being increasingly used for the targeted local reinforcement of plastic components in lightweight construction applications. An essential step in the production of UD tapes is fiber spreading, the aim of which is to expand fiber rovings from an initial width to a defined final width. Using a test rig under realistic conditions, we systematically investigated the factors that influence fiber spreading by deflection. Carbon-fiber rovings with various numbers of filaments were guided over deflection rods, and roving width before and after spreading was recorded with cameras. A full design of experiments (DoE) plan was set up, in which (i) the number of rods, (ii) rod diameter, (iii) immersion depth of the rod, and (iv) take-off speed of the fiber roving were systematically varied. We statistically evaluated the results of the experiments and found that the main factors that influenced the response variables investigated were number of rods and rod diameter, followed by immersion depth. We also observed that a higher number of filaments in the roving led to more complexity and greater variability. Our results can be used to optimize the spreading configuration in the production of UD tapes.
Slot dies are crucial for shaping operations in flat-film and sheet extrusion processes. For die design and process analysis, modeling of the flow within the die is essential. Alongside computational fluid dynamics (CFD) simulations, network theory – a computationally less expensive, semi-numerical approach – is used to predict, for instance, the pressure-throughput behavior and residence time. In many applications, the products extruded consist of multilayer structures that are formed from stratified flows fed into the slot die. In the absence of explicit expressions for the die conductance of co-extrusion flows, the application of network theory has hitherto been limited to mono-extrusion die flows. In this work, application of network theory was extended to include non-Newtonian two-layer co-extrusion flows in slot dies with rectangular manifold channels. First, a hybrid flow-modeling approach was employed to derive generalized symbolic regression models that predict relevant flow parameters (e.g., pressure-throughput behavior and average shear rates per layer) for two-layer slit flows of power-law fluids. These analytical expressions were then integrated into the flow network. A local power-law approach was chosen to describe the rheological behavior of the melts, for which an additional iterative loop was implemented to evaluate the average shear rate per layer (i.e., representative shear rate) for each network element. Solutions using this extended network approach are both fast and accurate, as confirmed by validation against results from CFD simulations.
28 September 2025 in Journal of Engineered Fibers and Fabrics
Unidirectional fiber-reinforced thermoplastic (UD) tapes are used increasingly in lightweight construction for local reinforcement of plastic parts. A critical step in UD tape manufacturing is spreading of the fiber rovings by mechanical, electrostatic, pneumatic, or acoustic means to obtain a homogeneous carpet. This is a prerequisite for homogeneous impregnation, which in turn is a requirement for defect-free reinforced components. A major challenge in fiber spreading is the inconsistent and scattering width of the fiber rovings within a bobbin or between different bobbins caused by the manufacturing process of the rovings. Especially for heavy tows – carbon-fiber rovings consisting of more than 24K filaments – variable input quality of the rovings renders obtaining a constant final roving width with existing spreading techniques impossible. We propose a novel spreading technique based on the principle of forced conveying that aims to provide constant final widths that are largely independent of the quality of the input roving. In a feasibility study, we investigated the forced conveying spreading behavior of a 60K carbon fiber roving; our new spreading method provided constant final widths independent of initial width and cross-sectional shape. Statistical analysis showed that both the wrap angle and the circumferential speed of the roller and their quadratic influences have highly significant effects on the final spread width. With an of 0.9972, the quadratic model determined has good predictive accuracy for the spread width in the measured range.