The hydrodynamic and thermal interaction of water with the high-temperature melt of a heavy metal was studied via the Volume-of-Fluid (VOF) method formulated for three immiscible phases (liquid melt, water, and water vapor), with account for phase changes. The VOF method relies on a first-principle description of phase interactions, including drag, heat transfer, and water evaporation, in contrast to multifluid models relying on empirical correlations. The verification of the VOF model implemented in OpenFOAM software was performed by solving one- and two-dimensional reference problems. Water jet penetration into a melt pool was first calculated in two-dimensional problem formulation, and the results were compared with analytical models and empirical correlations available, with emphasis on the effects of jet velocity and diameter. Three-dimensional simulations were performed in geometry, corresponding to known experiments performed in a narrow planar vessel with a semi-circular bottom. The VOF results obtained for water jet impact on molten heavy metal (lead–bismuth eutectic alloy at the temperature 820 K) are here presented for a water temperature of 298 K, jet diameter 6 mm, and jet velocity 6.2 m/s. Development of a cavity filled with a three-phase melt–water–vapor mixture is revealed, including its propagation down to the vessel bottom, with lateral displacement of melt, and subsequent detachment from the bottom due to gravitational settling of melt. The best agreement of predicted cavity depth, velocity, and aspect ratio with experiments (within 10%) was achieved at the stage of downward cavity propagation; at the later stages, the differences increased to about 30%. Adequacy of the numerical mesh containing about 5.6 million cells was demonstrated by comparing the penetration dynamics obtained on a sequence of meshes with the cell size ranging from 180 to 350 µm.
High-temperature melt spreading under a shallow water layer can lead to energetic interaction, known as the stratified steam explosion. One of the key uncertainties in the current understanding of this phenomenon is the mechanism for the formation of a premixed zone above the melt layer. It is known that the most energetic steam explosions occur when dispersed melt droplets are mixed with water in a certain proportion. There exists experimental evidence that high-temperature melt spreading is featured by intensive disturbances of the melt surface, visible as sporadic splashes to the height of about few centimeters. In this work, numerical simulations are performed on the interaction of a melt pool with water jets impinging on the free melt surface. Three phases are considered: melt, water, and vapor; the interfaces are modeled by the Volume of Fluid (VOF) method. Phase change is taken into account on the water-vapor interface. The problem is solved numerically in two- and three-dimensional framework. Firstly, impingement of a short-duration vertical water jet on the melt surface is studied, with the parametric analysis performed to establish the effect of the jet characteristics (mass, velocity, diameter) on the primary (due to development of a cavity on the melt surface) and secondary (central jet due to cavity collapse) splashes. Secondly, three-dimensional simulations are presented demonstrating the development of vapor film instability in an initially three-layered configuration (melt and water layers separated by a thin vapor film). Implication for the steam explosion problem is discussed.
Numerical and experimental results for the problem of melting of a paraffin sample in a high-temperature gas flow are given. Two-dimensional numerical simulation was carried out using the volume-of-fluid (VOF) method within the framework of the OpenFOAM software package. A good agreement between the shape of samples obtained as a result of experiments and that found from numerical calculations is observed. Acceptable agreement for the sample regression rate in the cases corresponding to various temperatures and air flow rates is obtained. The observed formation of a liquid paraffin layer and its disturbances due to the development of Kelvin–Helmholtz instability are in qualitative agreement for both methods of study. Quantitative comparison of the wavelengths that characterize the melt surface disturbances makes it possible speak about the potential of the VOF method for problems requiring detailed resolution of the interphase boundary structure.
13 December 2023 in MORSKIE INTELLEKTUAL`NYE TEHNOLOGII