A new adsorbent material was prepared by coating an activated carbon with hydrothermal carbon obtained from sucrose. The material obtained has different properties from the sum of the properties of the activated carbon and the hydrothermal carbon, which shows that a new material was obtained. It has a high specific surface area (1051.9 m2 g−1) and is slightly more acidic than the starting activated carbon (p.z.c.-point of zero charge 8.71 vs. 9.09). The adsorptive properties of a commercial carbon (Norit RX-3 Extra) were improved over a wide pH and temperature range. The capacity values of the monolayer according to Langmuir’s model reached 588 mg g−1 for the commercial product and 769 mg g−1 for the new adsorbent.
This study deals with the preparation of adsorbents from a commercial xerogel by chemically modifying its surface with concentrated mineral acids and alkali metal chlorides, their physicochemical characterization, and their use as adsorbents for gallic acid in aqueous solution. Although there are publications on the use of carbon xerogels as adsorbents, we propose and study simple modifications that can change their chemical properties and, therefore, their performance as adsorbents. The adsorbate of choice is gallic acid and, to our knowledge, there is no history of its adsorption with carbon xerogels. The prepared adsorbents have a high specific surface area (347–563 m2 g−1), better pore development for samples treated with alkali metal chlorides than with mineral acids, and are more acidic than the initial xerogel (p.z.c range 2.49–6.87 vs. 7.20). The adsorption equilibrium is reached in <16 h with a kinetic constant between 0.018 and 0.035 h−1 for the pseudo-second-order model. The adsorption capacity, according to the Langmuir model, reaches 62.89 to 83.33 mg g−1. The adsorption properties of the commercial xerogel improved over a wide range of pH values and temperatures. The experimental results indicate that the adsorption process is thermodynamically favored.
Acetaminophen (APAP) is a widely used pharmaceutical increasingly detected as a contaminant in aquatic environments due to its persistent nature and incomplete removal by conventional wastewater treatment. This study investigates the adsorption performance and mechanisms of commercial activated carbon (M) and its hydrothermally modified form (MH) for APAP removal. Characterization via elemental analysis, X-ray photoelectron spectroscopy (XPS), and N2 adsorption isotherms revealed that hydrothermal treatment reduced oxygen content and enhanced micro- and mesopore volumes, resulting in a more homogeneous and carbon-rich surface. Batch adsorption experiments conducted under varying pH (5–7) and temperature (30–40 °C) conditions showed that MH achieved up to 94.3% APAP removal, outperforming the untreated carbon by more than 15%. Kinetic modeling indicated that adsorption followed a pseudo-second-order mechanism (R2 > 0.99), and isotherm data fitted best to the Langmuir model for MH and the Freundlich model for M, reflecting their differing surface properties. Adsorption was enhanced at lower pH and higher temperatures, consistent with an endothermic and pH-dependent mechanism. Complementary density functional theory (DFT) simulations confirmed that π–π stacking is the dominant interaction between APAP and the carbon surface. The most favorable configuration involved coplanar stacking with non-oxidized graphene (ΔG = −33 kJ/mol), while oxidized graphene models exhibited weaker interactions. Natural Bond Orbital (NBO) analysis further supported the prevalence of π–π interactions over dipole interactions. These findings suggest that surface deoxygenation and improved pore architecture achieved via hydrothermal treatment significantly enhance APAP adsorption, offering a scalable strategy for pharmaceutical pollutant removal in water treatment applications.