A two-dimensional reflector with resistive-type boundary conditions and varying resistivity is considered. The incident wave is a beam emitted by a complex-source-point feed simulating an aperture source. The problem is formulated as an electromagnetic time-harmonic boundary value problem and cast into the electric field integral equation form. This is a Fredholm second kind equation that can be solved numerically in several ways. We develop a Galerkin projection scheme with entire-domain expansion functions defined on an auxiliary circle and demonstrate its advantage over a conventional moment-method solution in terms of faster convergence. Hence, larger reflectors can be computed with a higher accuracy. The results presented relate to the elliptic, parabolic, and hyperbolic profile reflectors fed by in-focus feeds. They demonstrate that a partially or fully resistive parabolic reflector is able to form a sharp main beam of the far-field pattern in the forward half-space; however, partial transparency leads to a drop in the overall directivity of emission due to the leakage of the field to the shadow half-space. This can be avoided if only small parts of the reflector near the edges are made resistive, with resisitivity increasing to the edge.
22 June 2021 in IET Microwaves, Antennas & Propagation
We consider two‐dimensional (2‐D) thin dielectric parabolic reflector, covered with graphene from both sides, illuminated symmetrically by an E‐polarized electromagnetic plane wave. Our aim is to estimate the focussing ability of such a composite reflector depending on the graphene parameters. We use a version of the two‐side generalized boundary condition, modified for a thin multilayer case. The scattering is formulated as an electromagnetic boundary‐value problem; it is cast to a set of two coupled singular integral equations that are further subjected to analytical regularisation based on the known Riemann–Hilbert problem solution. Thanks to this procedure, the numerical results are computed from a Fredholm second‐kind matrix equation that guarantees convergence and provides easily controlled accuracy. In the lower part of the THz range, high values of the focusing ability are observed even for a thin reflector; they are greater than for a purely dielectric reflector and a free standing graphene reflector. On the other hand, a regime of almost full transparency, intrinsic for the dielectric layer, can spoil focusing ability. Novel aspect is that the location in frequency of this effect can be controlled, in wide range, by changing the chemical potential of graphene.
20 November 2013 in Journal of Electromagnetic Waves and Applications
Electromagnetic scattering from a cylindrical reflector surface having an arbitrary conic section profile is studied. We assumed an electrically thin layer antenna illuminated by a complex line source in E-polarization mode. Our boundary value formulation, without loss of generality, involves an integral equation approach having impedance-type thin-layer boundary conditions. For simplicity, we also considered both faces of the reflector of the same uniform impedance value. Our computation employs the Method of Analytical Regularization (MAR) technique: the integral equations are converted into the discrete Fourier transform domain yielding two coupled dual series equations, which are then solved by the Fourier inversion and Riemann Hilbert Problem techniques. We demonstrate the accuracy and the convergence behaviors of our numerically solved MAR results that can serve as an accurate benchmark for comparison with widely used results obtained by approximate boundary conditions.
4 October 2017 in IET Microwaves, Antennas & Propagation
A thin, penetrable, and cylindrical reflector is illuminated by the incident field of a complex source point. The scattered field inside the reflector is not considered and its effect is modelled through a thin layer generalised boundary condition (GBC). The authors formulate the structure as an electromagnetic boundary value problem and two resultant coupled singular integral equation system of equations are solved by using regularisation techniques. The GBC provides us to simulate the thin layer better than the resistive model which is applicable only for very thin sheets. Hence, the more reliable data can be obtained for high‐contrast and low‐loss dielectric material. The scattering and absorption characteristics of the front‐fed and offset reflectors are obtained depending on system parameters. Also, the effects of the edge loading are examined for both E‐ and H‐polarisations. The convergence and the accuracy of the formulation are verified in reasonable computational running time.
1 January 2011 in Turkish Journal of Electrical Engineering and Computer Sciences
Electromagnetic scattering from strips of layers is analyzed using the method of moments (MoM) for both polarizations in spatial domain with the sinc-type orthogonal sets as basis and testing functions. We exploited the sinc function's properties of exponential convergence, the orthogonality, easy convolution and better handling of singular kernels in MoM procedure resulting in fast performance and reasonable accuracy even in ordinary MoM treatment. We transferred the integral of the Hankel function multiplied by sinc functions to Hankel function introducing a slight error with large band width. We proved that this relative error during the generation of the main matrix elements is smaller than that of the free space error, i.e., 1%--0.5% for considerably large matrix sizes. Our approach is readily applicable to a singular kernel problem due to properties of the sinc functions in particular 2D geometry. The procedure undertaken here is proven to be very efficient as regard to similar treatments in the literature developed mainly for regular kernels. Various numerical results are calculated such as the surface induced current and normalized far field radiation pattern. We compared them with the results available in the literature.