Due to the growing demand for new ecological, low-emission heat sources, there is a need to develop new tools for simulating the operating parameters and costs of the implemented solutions. The article analyses the existing solutions for the simulation of heat pump operation parameters, describes the requirements for a modern building—nZEB and proposes a simulation tool based on thermodynamic parameters of the refrigerant. The script allows for deriving simple linear equations that can be used for the overall simulation of a system in which the heat pump is a key part and the efficiency of the entire system depends on its performance. The developed numerical script allows for reproducing the Linde refrigeration cycle and the parameters of its characteristic points. To calibrate the simulation, historical data obtained from the SOPSAR system were used. These data were pre-cleaned (peaks and other obvious measurement errors were removed). The obtained numerical model in combination with ground and air temperatures, anticipated hot water consumption and energy losses of the building can be used to simulate the annual performance and energy consumption of the heat pump. The obtained linear models have an RSMD error of 8% compared to historical data from SOPSAR system for all sets of simulated temperatures.

Occurrences associated with the phenomena of climate change are increasingly visible. Effects of progressive environmental pollution are monitored with growing concern. Still, in the construction sector, the choice of sustainable materials and the knowledge concerning them is insignificant. Studies have shown that single-family residential buildings form the largest share of new buildings in Central European countries. It should be assumed that it is the improvement of this particular section of the construction sector to be the goal of further development of societies. This paper presents a case study of the construction of a house using straw - a material that, on the one hand, is a product associated with local tradition, while significantly reducing carbon footprint of its production and use, on the other. The construction of a prototypical house with the application of composite technology, i.e. timber framing with straw bale infill, was compared with a conventional method (ceramic masonry units) which is currently the most popular choice for building single-family houses in Poland. The study is based on the building’s life cycle assessment (LCA) over its consecutive phases as a tested and reliable method of the verification of a material’s impact on the environment.

STRESZCZENIE Artykuł przedstawia działania związane z interwencją w strukturę miasta, wynikające z sytuacji kryzysowej spowodowanej pandemią. Jest to próba budowy planu naprawczego dla otoczenia przychodni w Wieliczce oparta o metody projektowania w niedługim okresie czasu. Plan uwzględnia szeroki zakres problemowy, nie tylko ten wynikający bezpośrednio ze skutków pandemii.

Architektura jako narzędzie rozwiązywania wybranych problemów społecznych – na przykładzie Leżajska, Niepołomic i Wieliczki