The offshore wind sector is moving into deep waters and using floating platforms to harness the higher wind speeds in exposed locations. There are various floating platform types currently in development, but semi-submersibles are considered the most prominent early movers. Such floaters need to be towed to and from wind farm locations for installation, special cases of repair and decommissioning. As with any other offshore activity, metocean limits exist for towing operations which can impact the development of a wind farm. It is important to calculate the motion and loads of the platform before commencing the towing operations and to check whether they exceed the defined limits to enable safe execution. In this paper, two approaches using two different numerical tools to predict the motion of a fully assembled floating wind platform under tow are presented and compared. A potential flow-based method derived from a low forward speed approach and a hybrid approach combining potential flow and Morison equation methods are investigated, and the numerical predictions are compared and validated against experimental results. Both methods demonstrate accurate predictions, depending on the wave condition and towing speed, albeit differing in execution time and the simplicity of the simulation setup. The first method was found to provide good predictions of the motion in low-speed (0.514–1.543 m/s) towing conditions. The second method provides better results for all the towing speeds and wave heights. As the wave height and towing speed increase, deviations from experiments were observed, signifying non-linear phenomena that are difficult to analyse using the mentioned potential-flow-based methods.

A robust pipeline of floating wind energy has emerged with a general trend of projects becoming larger, further from shore, and placed in increasingly energetic seas. The installation process for these farms involves the pre-assembly of components onshore or in sheltered waters before towing the platform to the operational location using tugs. It can be expected that such marine operations will be repeated in reverse at the time of decommissioning. The cost and safety of these operations will be influenced by the tugs used, towing speed, the local metocean conditions, the platform/turbine characteristics and other factors. This paper investigates the hydrodynamic characteristics of a large semi-submersible floating offshore wind turbine (FOWT) under tow. The motions of the FOWT are analysed using a numerical tool and validated using a towing test. A framework is proposed for the assessment of FOWT towing operations. Various limiting factors have been identified and the hydrodynamic performance of the system has been evaluated using the framework.