Infrared and visible image match is an important research topic in the field of multi-modality image processing. Due to the difference of image contents like pixel intensities and gradients caused by disparate spectrums, it is a great challenge for infrared and visible image match in terms of the detection repeatability and the matching accuracy. To improve the matching performance, a feature detection and description method based on consistent edge structures of images (DDCE) is proposed in this paper. First, consistent edge structures are detected to obtain similar contents of infrared and visible images. Second, common feature points of infrared and visible images are extracted based on the consistent edge structures. Third, feature descriptions are established according to the edge structure attributes including edge length and edge orientation. Lastly, feature correspondences are calculated according to the distance of feature descriptions. Due to the utilization of consistent edge structures of infrared and visible images, the proposed DDCE method can improve the detection repeatability and the matching accuracy. DDCE is evaluated on two public datasets and are compared with several state-of-the-art methods. Experimental results demonstrate that DDCE can achieve superior performance against other methods for infrared and visible image match.
Effective utilization of energy resources in Wireless Sensor Networks (WSNs) has become challenging under uncertain distributed cluster-formation and single-hop intercluster communication capabilities. So, sensor nodes are forced to operate at expensive full rate transmission power level continuously during whole network operation. These challenging network environments experience unwanted phenomena of drastic energy consumption and packet drop. In this paper, we propose an adaptive immune Multihopping Multilevel Clustering (MHMLC) protocol that executes a Hybrid Clustering Algorithm (HCA) to perform optimal centralized selection of Cluster-Heads (CHs) within radius of centrally located Base Station (BS) and distributed CHs selection in the rest of network area. HCA of MHMLC also produces optimal intermediate CHs for intercluster multihop communications that develop heterogeneity-aware economical links. This hybrid cluster-formation facilitates the sensors to function at short range transmission power level that enhances link quality and avoids packet drop. The simulation environments produce fair comparison among proposed MHMLC and existing state-of-the-art routing protocols. Experimental results give significant evidence of better performance of the proposed model in terms of network lifetime, stability period, and data delivery ratio.
Smart reconfiguration of a dynamic networking environment is offered by the central control of Software-Defined Networking (SDN). Centralized SDN-based management architectures are capable of retrieving global topology intelligence and decoupling the forwarding plane from the control plane. Routing protocols developed for conventional Wireless Sensor Networks (WSNs) utilize limited iterative reconfiguration methods to optimize environmental reporting. However, the challenging networking scenarios of WSNs involve a performance overhead due to constant periodic iterative reconfigurations. In this paper, we propose the SDN-based Application-aware Centralized adaptive Flow Iterative Reconfiguring (SACFIR) routing protocol with the centralized SDN iterative solver controller to maintain the load-balancing between flow reconfigurations and flow allocation cost. The proposed SACFIR’s routing protocol offers a unique iterative path-selection algorithm, which initially computes suitable clustering based on residual resources at the control layer and then implements application-aware threshold-based multi-hop report transmissions on the forwarding plane. The operation of the SACFIR algorithm is centrally supervised by the SDN controller residing at the Base Station (BS). This paper extends SACFIR to SDN-based Application-aware Main-value Centralized adaptive Flow Iterative Reconfiguring (SAMCFIR) to establish both proactive and reactive reporting. The SAMCFIR transmission phase enables sensor nodes to trigger direct transmissions for main-value reports, while in the case of SACFIR, all reports follow computed routes. Our SDN-enabled proposed models adjust the reconfiguration period according to the traffic burden on sensor nodes, which results in heterogeneity awareness, load-balancing and application-specific reconfigurations of WSNs. Extensive experimental simulation-based results show that SACFIR and SAMCFIR yield the maximum scalability, network lifetime and stability period when compared to existing routing protocols.
In the standard bag‐of‐visual‐words model, the relationship between visual words and geometric structure information embedding in Voronoi cells is important for expressing the topology of the feature space. However, this information is usually ignored by recent works. To overcome it, the authors proposed a hybrid heterogeneous structure model (HHSM), where local hyperspheres and local structure subspaces are applied to simulate the intrinsic structure of the feature space. Firstly, the local hypersphere is formed by choosing some links between parts of visual words, with the use of a proposed decision strategy derived from k ‐dense neighbour algorithm. In order to capture the geometric structure information around the visual word, they then construct the local structure subspace with the transformed PCA principal vectors of the visual features within a Voronoi cell. Finally, this study introduces a novel feature encoding method based on the HHSM. Experiments are conducted on 15‐Scenes, Pascal VOC2007, Caltech101, Caltech256 and MIT Indoor 67 datasets, which include 4485, 9963, 9146, 30607 and 15620 images, respectively. The results demonstrate the effectiveness of the proposed method in improving the accuracy of the classification. In addition, the proposed method achieves comparable performance when combined with CNN local features.