Rotating detonation experiments were conducted using CH4/CO/H2 (methane/carbon monoxide/hydrogen) mixtures with varying CO contents, the modes of rotating detonation wave (RDW) propagation in the mixtures were analyzed, and the impact of CO content on the propagation characteristics of the RDW in the gas mixture was compared. Three propagation modes of RDW were observed: sawtooth wave mode, mixed mode, and single wave mode. An increase in the CO content resulted in an upward shift in the range of working equivalence ratios for different gas mixtures. Additionally, the propagation modes of the same gas mixture change with increased fuel flow rate. When the equivalence ratio is below 1.13, it is observed that the gas mixture with the lowest CO content exhibits the highest RDW velocity and the shortest time required to establish RDW. This was attributed to the higher content of oxygen-containing functional groups, such as OH (hydroxyl), HO2 (peroxyhydroxyl), and O (oxygen atom), which were present under lean combustion conditions, along with the highest mass content of H2 in the gas mixture with the lowest CO content. Conversely, for equivalence ratios above 1.13, it is observed that the gas mixture with the highest CO content exhibits the highest propagation velocity and the shortest time required to establish RDW. This was attributed to the lowest mass content of CH4 and H2 in the gas mixture with the highest CO content at the same equivalence ratio, along with the inhibitory effect of elevated CO content on CH4 consumption under fuel-rich combustion conditions. The increase in the CO content resulted in maximum propagation velocities of the detonation wave being achieved for the three gas mixtures at equivalence ratios of 0.91, 1.09, and 1.19, with corresponding velocities of 1136.7, 1108.7, and 1113.2 m/s, and the shortest times required to establish RDW were measured at 1.5, 1.1, and 0.8 ms for the respective mixtures.
Gasoline compression ignition combustion has demonstrated the potential of getting high fuel efficiency. In this work, two engine models are established in the commercial software Converge 2.3 based on the experimental results of an optical engine and a modified metal engine. The effect mechanism of mixture stratification and the influence of compound control strategy on gasoline compression ignition (GCI) combustion and soot emissions under high load condition are investigated. Results show that synergistic effect of physics and chemistry is the dominant control mechanism of GCI combustion. Stronger mixture stratification can effectively reduce the maximum pressure rise rate (MPRR) and improve the indicated thermal efficiency (ITE) and emissions; applying high EGR will significantly reduce OH radical in the cylinder and subsequently weaken the soot oxidation process, resulting in high soot emission; under the premise of reasonable NOx emission and MPRR, the soot emission can be effectively reduced with a proper advanced main injection timing. The effect of temperature on the soot oxidation process is the primary mechanism for the ultimate soot emission at different main injection timings; properly increasing the interval between the pre‐ and main injection can reduce NOx and soot emissions under the premise of ensuring that the MPRR is within the upper limit. However, the effect is not significant because of the small proportion of preinjection fuel.