Karsten Henkel

Dr. Karsten Henkel

orcid

Research Focus & Metrics

Academic Career Length

28Years (1999-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
16 January 2020 in ACS Applied Polymer Materials
Verified
Journal Article
Closed access
Kuntal MaityKuntal Maity
Kuntal Maity
SGSamiran Garain
Samiran Garain
KHKarsten Henkel
Karsten Henkel
DSDieter Schmeißer
Dieter Schmeißer
DMDipankar Mandal
Dipankar Mandal

20 July 2015 in ACS Applied Materials & Interfaces
Verified
Journal Article
Closed access
ATAbiral Tamang
Abiral Tamang
SGSujoy Kumar Ghosh
Sujoy Kumar Ghosh
SGSamiran Garain
Samiran Garain
MAMehebub Alam
Mehebub Alam
JHJörg Haeberle
Jörg Haeberle
DMDipankar Mandal
Dipankar Mandal

1 December 2016 in Nano Energy
Verified
Journal Article
Closed access
SGSujoy Kumar Ghosh
Sujoy Kumar Ghosh
ABAnirban Biswas
Anirban Biswas
SSShrabanee Sen
Shrabanee Sen
CDChittaranjan Das
Chittaranjan Das
KHKarsten Henkel
Karsten Henkel
DMDipankar Mandal
Dipankar Mandal

27 February 2014 in Physical Chemistry Chemical Physics
Verified
Journal Article
Closed access
PDF file
DMDipankar Mandal
Dipankar Mandal
KHKarsten Henkel
Karsten Henkel
DSDieter Schmeißer
Dieter Schmeißer
We report on the electrospinning of poly(vinylidene fluoride–hexafluoropropylene) [P(VDF–HFP)] nanofibers doped with silver nanoparticles for the preparation of a polymer based nanogenerator (PNG). It has been found that the yield of the piezoelectric phase is increased by the addition of silver nanoparticles. Furthermore, defects in the P(VDF–HFP) electrospun fibers are removed resulting in a significant enhancement in the output power of the PNG. A maximum generated PNG output voltage of 3 V with a current density of 0.9 μA cm−2 is achieved.

19 December 2014 in ACS Applied Materials & Interfaces
Verified
Journal Article
Closed access
SGSamiran Garain
Samiran Garain
TSTridib Kumar Sinha
Tridib Kumar Sinha
PAPrakriti Adhikary
Prakriti Adhikary
KHKarsten Henkel
Karsten Henkel
SSShrabanee Sen
Shrabanee Sen
DMDipankar Mandal
Dipankar Mandal

8 November 2013 in Beilstein Journal of Nanotechnology
Verified
Journal Article
Open access
PDF file
JHJörg Haeberle
Jörg Haeberle
KHKarsten Henkel
Karsten Henkel
HGHassan Gargouri
Hassan Gargouri
FNFranziska Naumann
Franziska Naumann
BGBernd Gruska
Bernd Gruska
DSDieter Schmeißer
Dieter Schmeißer
We report on results on the preparation of thin (<100 nm) aluminum oxide (Al2O3) films on silicon substrates using thermal atomic layer deposition (T-ALD) and plasma enhanced atomic layer deposition (PE-ALD) in the SENTECH SI ALD LL system. The T-ALD Al2O3 layers were deposited at 200 °C, for the PE-ALD films we varied the substrate temperature range between room temperature (rt) and 200 °C. We show data from spectroscopic ellipsometry (thickness, refractive index, growth rate) over 4” wafers and correlate them to X-ray photoelectron spectroscopy (XPS) results. The 200 °C T-ALD and PE-ALD processes yield films with similar refractive indices and with oxygen to aluminum elemental ratios very close to the stoichiometric value of 1.5. However, in both also fragments of the precursor are integrated into the film. The PE-ALD films show an increased growth rate and lower carbon contaminations. Reducing the deposition temperature down to rt leads to a higher content of carbon and CH-species. We also find a decrease of the refractive index and of the oxygen to aluminum elemental ratio as well as an increase of the growth rate whereas the homogeneity of the film growth is not influenced significantly. Initial state energy shifts in all PE-ALD samples are observed which we attribute to a net negative charge within the films.