Qingyun Zhou

Dr. Qingyun Zhou

orcid

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
7 October 2024 in Frontiers in Earth Science
Verified
Journal Article
Open access
PDF file
QZQingyun Zhou
Qingyun Zhou
The Xiaojiang Fault and the Red River Fault, which are located on the southeastern margin of the Tibetan Plateau, are the eastern and southern boundaries of the Sichuan–Yunnan Block, respectively. The relationship between these two faults is highly important for the study on the tectonic evolution and seismic risk of the southeastern margin of the Tibetan Plateau. Using the digital elevation model (DEM) data, we extracted and analyzed the maximum elevation, peak steepness index, maximum slope, and relatively flat surface of the Ailaoshan Shear Zone on the southwest side of the Red River Fault. The results revealed that the geomorphic indices result around Yuanjiang were significantly lower than those on the northern and southern sides of Yuanjiang. On the basis of lithology, climate and tectonics, it is inferred that tectonic activity is the main factor controlling landform development. On the basis of existing geophysical and geomorphic survey results in this area, a geodynamic model of this area was constructed: in the mid-Miocene, tectonic inversion of the Red River Fault occurred, and material from the Tibetan Plateau flowed into the Sichuan‒Yunnan Block around the East Himalayan Syntax. The resulting extrusion caused the Red River Fault to bend of ∼50 km; in the early Pliocene, the middle and lower crust broke through the barrier and entered the interior of the Ailaoshan Shear Zone. Because of the extrusion of the middle and lower crust, the role of the Red River Fault as the boundary has weakened.

7 February 2025 in PLOS ONE
Verified
Journal Article
Open access
PDF file
QZQingyun Zhou
Qingyun Zhou
SHSuge He
Suge He
ZZZhenyu Zou
Zhenyu Zou
Fault displacement hazard, along with ground shaking hazard and earthquake-induced geohazard, are the primary forms of disaster in major earthquakes. Buildings located on areas of strong seismic surface displacement are likely to be damaged if anti-displacement design is not carried out. Therefore, a reasonable and targeted active fault classification scheme is helpful for avoidance and anti-displacement hazard of active fault in engineering construction. However, the existing classification schemes are rough, and some have no quantitative classification basis, which makes it difficult to apply these classification schemes in actual work. Also, they did not specify whether all active faults should be avoided. In this paper, considering the physical mechanism of earthquakes, using two activity parameters of active faults, “strong earthquake recurrence period” (TRP) and “strong earthquake elapsed time ratio” (Ret), and referring to the probabilistic seismic hazard analysis method (PSHA), the maximum magnitude of potential earthquake on the fault under different exceedance probabilities (EP) is calculated, and was divided into six levels. The fault displacement hazard level under different exceedance probabilities may be different. For buildings with different importance levels, we recommend six hazard classification schemes with different exceedance probabilities. Standard buildings should avoid active faults with a fault displacement hazard level of Ⅰ ~ Ⅲ (faults that can generate earthquakes of magnitude m0 and above under a 4% exceedance probability over 100 years). Special buildings and key buildings should avoid active faults with a fault displacement hazard level of Ⅰ ~ Ⅳ (faults that can generate earthquakes of magnitude m0-0.5and above under a 1% exceedance probability over 100 years). The fault displacement hazard classification scheme given in this paper takes into account the physical mechanism of earthquake occurrence and the importance of buildings, which makes this classification scheme both scientific and practical, helps provide technical support for the design and construction of buildings. This study is still quite preliminary, and there are many issues that need further study.

27 November 2023 in Vibroengineering PROCEDIA
Verified
Journal Article
Open access
PDF file
QZQingyun Zhou
Qingyun Zhou
RZRuxin Zhuang
Ruxin Zhuang
Based on the results of the seismic hazard survey in Yunnan Province, four exceedance probabilities of peak ground acceleration were converted into earthquake magnitudes using the empirical relationship between epicentral intensity and magnitude. By using logistic regression, earthquake magnitude, source depth, cover layer thickness, and fault type were used as independent variables to calculate the probability of co-seismic displacement for different earthquake magnitudes. Using the magnitude-displacement empirical model in the southwestern region of China, horizontal and vertical displacements were obtained with a 95 % confidence level. The results show that all Holocene faults have the ability to produce surface displacement, but from the perspective of probabilistic hazard, the probability of surface rupture in the short term is low, while the probability of surface rupture for each fault significantly increases over a long time scale. Buildings with different service lives should adopt different avoidance strategies, and buildings with shorter service lives (<50a) can consider not avoiding active faults.

1 December 2024 in Buildings
Verified
Journal Article
Open access
PDF file
QZQingyun Zhou
Qingyun Zhou
XYXiaoxiang Yuan
Xiaoxiang Yuan
Coseismic surface displacement can cause major damage to buildings located on faults. Therefore, it is important to quantitatively evaluate the future surface displacement of active faults. The commonly used deterministic evaluation methods often tend to overestimate surface displacement values, so researchers are working toward probabilistic fault displacement hazard analysis (PFDHA). However, the PFDHA assumes that earthquakes occur equally in time, which is not consistent with the physical mechanism of earthquake occurrence. Elastic rebound theory and paleoseismic research results show that the accumulation and release of energy in the crustal medium have cyclical characteristics. In this study, using two parameters, the strong earthquake recurrence period (TRP) and strong earthquake elapsed time (tet), of active faults, the displacements of active faults with different TRP and tet under different exceedance probabilities are obtained. The calculation results indicate that the surface displacement hazard of the weakly active and extremely weakly active faults in the Holocene does not need to be considered; for the moderately and strongly active faults in the Holocene, the surface displacement result is lower than that provided by the deterministic method. According to the importance of the project, the calculation results of the PFDHA-td method under different exceedance probabilities are selected.

1 January 2025 in Open Geosciences
Verified
Journal Article
Open access
PDF file
QZQingyun Zhou
Qingyun Zhou
JLJingnan Liu
Jingnan Liu
PTPeng Tian
Peng Tian
WLWeidong Luo
Weidong Luo
XBXianfu Bai
Xianfu Bai
ZZZhenyu Zou
Zhenyu Zou
Coseismic surface displacements pose a serious threat to the safety of linear infrastructures on active faults. A reasonable evaluation of surface displacements on active faults is important. Probabilistic fault displacement hazard analysis (PFDHA) is often used for surface displacement evaluation. However, PFDHA, developed based on the classical probabilistic method, requires an in-depth study of the activity parameters of all active faults in seismic–tectonic zones, greatly limiting its application in engineering design. The recurrence interval of strong earthquakes is a readily obtainable parameter of fault activity. In this study, we combine this key parameter with various seismic indicators to develop a comprehensive algorithm to assess potential future surface displacement hazards. In addition, the factors affecting the method are analyzed, and the surface displacements of several earthquakes with a magnitude of 7 or above are compared. The results indicate that the predicted future surface displacements using our method are greater than the true displacements of seismic events. For easy use, the exceedance probability–displacement (horizontal and vertical) curves of 27 strong earthquake recurrence intervals are given. This facilitates structural designers to quickly obtain future displacement values in structural design.

9 October 2026 in Bulletin of the Seismological Society of America
Verified
Journal Article
Open access
QZQingyun Zhou
Qingyun Zhou
NSNan Sun
Nan Sun
PWPeng Wang
Peng Wang
JLJingnan Liu
Jingnan Liu
SHSuge He
Suge He
QLQi Liu
Qi Liu
Earthquake forecasting along active faults is important for reducing future seismic losses, especially in active zones such as Yunnan Province. However, the major earthquake recurrence patterns of faults in Yunnan remain understudied, and the time-dependent probabilities are still unclear. Here, we collected paleoseismic data on 20 fault segments in Yunnan, fit these data using four types of renewal processes, and calculated the probability of at least one major earthquake occurring on each segment over the next 30 yr. Approximately half of the fault segments show evidence of quasi-periodic recurrence, as indicated by the 95% credible intervals of their shape parameters being inconsistent with the random recurrence boundary. The Weibull renewal process is more likely to best reproduce recurrence times, followed by the lognormal renewal process. Five (≥4%) fault segments have relatively high earthquake occurrence probabilities. We also estimated the distribution of next-event times and found that fault segments with higher earthquake probabilities generally tend to have earlier expected times for the next earthquake. In this study, we conducted long-timescale recurrence analysis under restrictive assumptions, without taking into account multisegment rupture, stress interaction, and magnitude-specific modeling. Therefore, further research is required in these aspects in follow-up research.