We present a flexible method to study the optical properties of an ensemble in accessed via resonant excitation and in situ single-photon detection. The technique allows an efficient resonant photoluminescence detection of optically active centers with weak oscillator strength in transparent crystals without the need for nanofabrication on the sample. We observe 70 resonances in , of which 62 resonances have not been observed in the literature, with optical lifetimes ranging from 0.5 to 1.5 ms. We observe inhomogeneous broadening of less than 400 MHz and an upper bound on the homogeneous linewidth of 0.75 and 1.4 MHz for two separate resonances. These narrow, stable resonances confirm in as a promising quantum information candidate. We discuss the use of this technique for rapid characterization of future samples, with the aim of enhancing the prevalence of sites which are favorable for quantum information applications.
The use of simple quantum processes promises to provide numbers that no physical observer could predict, but in practice, unwanted noise and imperfect devices can compromise fundamental randomness and protocol security. The ultimate random number generators take advantage of quantum nonlocality to certify unpredictability—including to an adversary—even in the absence of trust in devices. We demonstrate a generator of public or private randomness based on the quantum steering task. We use polarization-entangled photon pairs to certify and extract randomness in a one-sided device-independent framework, with the detection loophole closed. Our work enables nonlocality-based certified randomness generation in environmental regimes where fully-device-independent protocols are not feasible.
Silicon carbide (SiC) is widely used in many research fields because of its excellent properties. The femtosecond laser has been proven to be an effective method for achieving high-quality and high-efficiency SiC micromachining. In this article, the ablation mechanism irradiated on different surfaces of 6H-SiC by a single pulse under different energies was investigated. The changes in material elements and the geometric spatial distribution of the ablation pit were analyzed using micro-Raman spectroscopy, Energy Dispersive Spectrum (EDS), and an optical microscope, respectively. Moreover, the thresholds for structural transformation and modification zones of 6H-SiC on different surfaces were calculated based on the diameter of the ablation pits created by a femtosecond laser at different single-pulse energies. Experimental results show that the transformation thresholds of the Si surface and the C surface are 5.60 J/cm2 and 6.40 J/cm2, corresponding to the modification thresholds of 2.26 J/cm2 and 2.42 J/cm2, respectively. The Raman and EDS results reveal that there are no phase transformations or material changes on different surfaces of 6H-SiC at low energy, however, decomposition and oxidation occur and then accumulate into dense new phase material under high-energy laser irradiation. We found that the distribution of structural phase transformation is uneven from the center of the spot to the edge. The content of this research reveals the internal evolution mechanism of high-quality laser processing of hard material 6H-SiC. We expect that this research will contribute to the further development of SiC-based MEMS devices.
A novel confocal controlled Raman-LIBS hybrid microscope, with a high spatial resolution and antidrift property, has been developed. The microscope provides valuable compositional and structural analysis and is a powerful tool to study unknown minerals.