Microparticles of radioactive cesium (Cs)-bearing silicate glass emitted from the Fukushima Daiichi nuclear power plant were investigated mainly using state-of-the-art energy-dispersive X-ray spectroscopy in scanning transmission electron microscopes. Precise elemental maps of the particles were obtained using double silicon drift detectors with a large collection angle of X-rays, and qualitative elemental analysis was performed using high-resolution X-ray spectroscopy with a microcalorimetry detector. Beside the substantial elements (O, Si, Cl, K, Fe, Zn, Rb, Sn and Cs) as previously reported, Mn and Ba were also common, though their amounts were small. The atomic ratios of the substantial elements were not the same but varied among individual particles. Fe and Zn were relatively homogeneously distributed, whereas the concentration of alkali ions varied radially. Generally, Cs was rich and K and Rb were poor outward of the particles but the degree of such radial dependence was considerably different among the particles. A concentration of Sn on the particle surface was observed. High-resolution imaging indicated the formation of SnO 2 (cassiterite) nanocrystals on the surface. Synthesis of the bulk glass with a similar composition to the microparticles was attempted by quenching the silicate melt from ∼1600°C. However, homogeneous silicate glass like that of the microparticles could not be obtained due to the segregation of nano-spherules rich in Fe and Zn, suggesting that the microparticles were formed in a very specific condition in the nuclear reactor.
High electric conductivity was achieved in ZnO films prepared by a low-temperature (<100 °C) wet-chemical process and subsequent UV treatment by a commercial blacklight-blue lamp with a central wavelength of 360 nm and output power of 2.0 mW cm−2. The UV treatment to the as-deposited film successfully decreased the electric resistivity of the film by three orders of magnitude from 11 to 4.4 × 10−3 Ω cm. The resistivity was not restored to the initial value even after dark storage for 50 days, indicating that the decrease of the resistivity has not mainly originated from conventional persistent photoconductivity. The results of Hall measurement and Fourier transformed infrared measurement showed that an increase of carrier concentration and decomposition of organic impurities of the films occurred simultaneously, which indicates that the phenomenon was caused by introduction of donor impurities such as hydrogen atoms, carbon species and oxygen vacancies into the ZnO lattice by the photocatalytic decomposition of residual organic impurities remaining in the film.
Networked three-dimensional (3D) nanoporous alumina nanostructures—consisting of vertical cylindrical stem pore arrays (170–310 nm in diameter) and periodical transverse branched pores (20–80 nm in diameter) interspaced regularly by 190–220 nm across the vertical pore walls—were controllably fabricated from low purity Al materials (99.0%, 99.3%, and 99.56%) by anodization in a phosphoric acidic solution at 110–190 V. The formation of transverse pores depended predominantly on the purity of the Al base materials and the corrosion resistance of the anodic porous alumina films, which can be mainly attributed to anodic and/or chemical dissolution of impurities such as Fe, Cu, Zn, Mg, and Mn incorporated in the Al base materials. Moreover, the effects of the purity of Al materials on the growth and morphology of porous alumina films in oxalic and sulfuric acid solutions were also investigated by a two-step anodization of Al sheets with different purities, namely 99.0%, 99.3%, 99.56%, and 99.999% Al. The alumina films grew more slowly in all electrolytes with decreasing Al purity, which can be attributed to the lower corrosion resistance of the PAA films containing small quantities of Fe oxides and/or hydroxides produced during anodization.