The light sources operating in the spectral range 1600-1800 nm are of great interest because of a number of potential scientific and practical applications. This stimulates a search for effective laser media for this wavelength region. Recent progress in the studying of bismuth (Bi)-doped fibers is related to the development of Bi-doped high-germania-core fibers for the mentioned wavelength region. This paper is concerned with the current state of the art in the research field of this kind of the laser-active fibers. The fabrication and spectroscopic properties of the Bi-doped high-germania-core fibers are described. The photo-induced bleaching and recovery stimulated by thermal treatment of luminescent centers in these fibers are presented. The review also includes the description of the basic parameters of the optical devices (continuous wave (CW) and pulsed lasers, amplifiers, superluminescent sources) developed using Bi-doped high-germania-core fibers.
Bi- and Er-codoped germanosilicate optical fibers have been fabricated and studied as a potential gain medium for fiber-based devices operating in the near infrared region. A broadband optical amplifier operating in the wavelength range from 1515 to 1775 nm has been realized using the developed bismuth- and erbium-codoped fibers. The 15 dB small-signal gain band covers 260 nm when pumped by a laser diode at 1460 nm with an output power of 350 mW.
We report on a new record in the field of broadband BDFA in the O+E spectral range. Using only 250 mW single wavelength pump at 1256 nm and a low-OH bismuth-doped fiber containing two types of bismuth active centers, we achieved >23 dB gain from 1325 nm to 1441 nm with flatness <3 dB and a NF of <6.8 dB. Three different pump wavelengths were considered: 1230, 1256, 1270 nm. Pumping at the shortest wavelength enabled wider gain bandwidth – 125 nm but required pump power up to ∼620 mW, whereas the longest one provided higher pump efficiency but narrower gain bandwidth. We also studied multiple wavelength amplification effects in the BDFA to reveal potential problems with simultaneous broadband signal amplification in such amplifiers.
We demonstrate, to the best of our knowledge, the first bismuth-doped fiber laser operating at 1.7 μm mode-locked by means of Kerr nonlinearity. The laser setup has a figure-of-eight all-fiber design with a nonlinear amplifying loop mirror (NALM) and yields 17 ps pulses with a 3.57 MHz repetition rate and the energy 84 pJ. Using the master oscillator power amplifier scheme with a bismuth fiber amplifier, the output pulse energy of 5.7 nJ was achieved. Further pulse compression in the fiber compressor shortened pulses to 630 fs. The operation of the master oscillator was modeled using the nonlinear Schrödinger equation. Calculated data are in good agreement with experimental results.
During last decades there has been considerable interest in developing a fiber amplifier for the 1.3- $$\upmu $$ m spectral region that is comparable in performance to the Er-doped fiber amplifier operating near 1.55 $$\upmu $$ m. It is due to the fact that most of the existing fiber-optic communication systems that dominate terrestrial networks could be used for the data transmission in O-band (1260–1360 nm), where dispersion compensation is not required, providing a low-cost increase of the capacity. In this regard, significant efforts of the research laboratories were initially directed towards the study of the praseodymium-doped fluoride fiber amplifier having high gain and output powers at the desired wavelengths. However, despite the fact that this type of amplifiers had rapidly appeared as a commercial amplifier prototype it did not receive widespread demand in the telecom industry because of its low efficiency. It stimulated the search of novel optical materials for this purpose. About 10 years ago, a new type of bismuth-doped active fibers was developed, which turned out to be a promising medium for amplification at 1.3 $$\upmu $$ m. Here, we report on the development of a compact and efficient 20-dB (achieved for signal powers between $$-40$$ and $$-10$$ dBm) bismuth-doped fiber amplifier for a wavelength region of 1300–1350 nm in the forward, backward and bi-directional configurations, which can be pumped by a commercially available laser diode at 1230 nm with an output power of 250 mW. The compactness of the tested amplifier was provided by using a depressed cladding active fiber with low bending loss, which was coiled on a reel with a radius of 1.5 cm. We studied the gain and noise figure characteristics at different pump and signal powers. A record gain coefficient of 0.18 dB/mW (at the pump-to-signal power conversion efficiency of above 27 $$\%$$ ) has been achieved.