The design and analysis of a four-port multi-input multi-output (MIMO) super wideband antenna (SWB) with a metamaterial superstrate are proposed. Initially, a single antenna is constructed with a hexagonal radiator loaded with dodecagon slots along with a slotted partial ground. An impedance bandwidth of 4.1–14.7 GHz is achieved by using symmetric coplanar waveguide feeding technique and three iterations of dodecagon slot-loaded radiating element. The design is extended to a 2 × 2 MIMO antenna with dimensions 50 × 50 × 1.6 mm3. The four symmetrical SWB antennas are placed orthogonally to each other at four corners of a square-shaped FR4 substrate. A metamaterial superstrate is used above the four-port antenna to increase the antenna’s performance characteristics. A 7 × 7 array of rectangular metamaterial unit cells acts as a building block for the metamaterial superstrate to improve impedance matching, enhance isolation between the elements, and boost the antenna’s gain. The metamaterial unit cells are made up of three rectangular rings that are put on top of a 1.6 mm thick FR4 substrate. With a mutual coupling of (>15 dB), the antenna achieved S11 < −10 dB for an impedance bandwidth of 11 GHz. The gain enhancement of up to 1.73 dB is obtained in C and X bands using metamaterial superstrate. The antenna characteristics mainly peak gain, return loss, bandwidth, and isolation are examined. The simulated results affirm a decent deal with experimental results.
18 May 2022 in International Journal of System Assurance Engineering and Management
A modified symmetric split ring resonator (MSSRR) loaded bowtie antenna with multi-band features over a range of 1.6–7.1 GHz is proposed in this paper. The antenna is designed on FR4 substrate with relative permittivity εr = 4.1 and thickness 1.5 mm. The fabricated antenna size is 40 mm × 58 mm. The Modified Symmetric SRR used beneath the substrate is novel and consists of two circles that are broken into four quarter circles by four rods. The effect of MSSRR location and its geometry is investigated and analysed thoroughly. The measurement results of the fabricated antenna are in good agreement with the simulation results, which confirms the proposed antenna design’s properties. ANSYS High Frequency Structural Simulator (HFSS) software is used for simulating the antenna.
Frequency Selective Surface (FSS) is widely used to enhance the gain of antenna & reduces Electromagnetic Interference (EMI). In this work, a novel Frequency Selective Surface (FSS) is designed, analyzed, and fabricated along with passive Radio Frequency Identification (RFID) reader antenna operating at global Ultra-High Frequency (UHF) for wireless RFID applications. The antenna & FSS sheet is fabricated on less costly FR4 substrate with resonant bandwidth of 860–960 MHz. The Fabry–Perot arrangement of FSS sheet with antenna increases the gain & directivity without modifying the antenna profile or increasing radiation patch size. The maximum measured gain is 9.8 dB & 7.2 dB with the Reflection coefficient (S11) of −35 dB & −15 dB at 910 MHz & 950 MHz respectively. The proposed antenna of dimension 40 mm by 40 mm is fabricated & tested for further experimental validation with measured read range longer than 8 m. The novelty in proposed work is integration of FSS with passive UHF RFID technology which can be effectively used in wireless RFID applications for improved read range, higher gain, lower power consumption & better immunity within the resonating band. The proposed antenna effectively isolates out-of-band frequencies from in-band frequencies over a required bandwidth reducing Electromagnetic Interference (EMI) for UHF RFID applications.