Orbital radars are used to monitor the state of the sea ice in the Arctic and Antarctic. The backscattering radar cross section (RCS) is used to determine the type of scattering surface. The power of the reflected signal depends on many factors, so the problem of separating sea ice and sea waves is not always unambiguous. Previous research has shown that microwave Doppler radar installed on aircrafts can be used to determine the boundary of sea ice. The width of the Doppler spectrum for wide or knife-like antenna beam depends on the statistical parameters of the reflecting surface, so sea ice and sea waves are easily separated. However, when installing a Doppler radar on a satellite, the spatial resolution becomes extremely low. In this research, we discuss the possibility of improving the spatial resolution by dividing the antenna footprint into elementary scattering cells. To do this, it is proposed to use the original incoherent synthesis procedure, which allows one to determine the dependence of the RCS on the incidence angle for an elementary scattering cell. Numerical modeling was performed and processing of model data confirmed that sea ice and sea waves are separated. The coefficient of kurtosis was used as a criterion in the algorithm. In addition, for sea waves, it is possible to determine the mean square slopes (mss) of large-scale waves, compared to the electromagnetic wavelength of sea waves along the sounding direction.

To obtain new information about surface waves, it is proposed to use an underwater acoustic wave gauge, and an assessment of its effectiveness can be performed using a numerical simulation and field experiment. A new device, an underwater acoustic wave gauge named “Kalmar”, was developed by the Institute of Applied Physics of the Russian Academy of Sciences for long-term, all-weather monitoring of wind waves. The instrument uses ultrasound to probe the water surface from underwater and can be used to verify remote sensing data. In this work, the capabilities of the device are tested and compared with ADCP data. Two independent methods for processing underwater acoustic wave gauge data are discussed and compared. One of them is completely new for acoustic measurements and is based on the analysis of the shape of the reflected acoustic pulse averaged over space and time. The other allows processing individual reflected pulses and calculating the time implementation of the distance to the water surface. It is shown that two independent methods of significant wave height retrieval from the acoustic wave gauge measurements are highly correlated. The “Kalmar” acoustic wave gauge and the RDI WH-600 acoustic Doppler current profiler operated simultaneously at the test site in Gelendzhik from 1 February to 10 February 2020. The significant wave heights measured by the two instruments are in good agreement.