Incremental sheet forming is a novel approach and advanced manufacturing process in industries, where it is capable of producing complex geometrical components with high accuracy. In this study, Ti-6Al-4V material used in aircraft, naval ships, spacecraft, armour plating and missiles was considered to determine the formability in the incremental sheet forming process. A 20 set of experiments were conducted considering three process variables such as tool rotational speed, step depth and feed rate on the response variables such as formed wall thickness, surface roughness, thrust force and wall angle. The process parameters are optimized using the grey relational analysis method to achieve a better quality of products. By execution multi-objective optimization using grey relational analysis, it is observed that 200 r/min tool rotational speed, 0.1 mm step depth and 2000 mm/min feed rate are optimum parameter settings.
24 February 2023 in Transactions of the Indian Institute of Metals
In this study, hybrid composites consisting of AZ31 alloy matrix reinforced with 2 wt% aluminum oxide nanoparticles (Al2O3) and 2, 4, or 6 wt% silicon nitride microparticles (Si3N4) have been prepared using the stir casting route. The mechanical properties, such as hardness, tensile strength, compression strength, impact strength, and sliding wear performance, were evaluated for the fabricated hybrid composites. The mechanical properties improve significantly with the inclusion of reinforcement content. The hybrid composite having 4 wt% Si3N4 reinforcement exhibits higher mechanical properties like micro-hardness (68.8 HV), tensile strength (172 MPa), percentage of elongation (11.9%), compression strength (278 MPa), and impact strength (6.4 J). The wear rate and coefficient of friction tend to reduce with the inclusion of Si3N4 reinforcement content under dry sliding wear conditions. Worn-out surface micrograph investigation displays wear mechanisms such as abrasive wear and plastic deformation with micro–ploughing and micro-cutting.
19 January 2023 in Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering
Hybrid metal matrix composites are gaining more importance in recent years. In this current investigation, aluminium alloy (AA7075) composites have been prepared with nano tungsten carbide (WC) and molybdenum disulfide (MoS 2 ) as reinforcements using stir casting method and investigated. The nano tungsten carbide particles were added into the matrix in the proportions 0%, 0.5%, 1%, 1.5% and 2%, and molybdenum disulfide was added in the constant proportion of 5 wt.% to the molten metal. The prepared Al-hybrid composite samples were tested for their hardness, compression and tensile strength. Microstructure examination has also been performed to understand the distribution pattern of nano tungsten carbide and molybdenum disulfide particles in the base matrix by scanning electron microscope. From the results, it was found that there was steady improvement in composite properties when compared with the base metal while adding WC and MoS 2 . Thus, the prepared AA7075/MoS 2 /WC composites were guaranteed for high strength, hardness and exceptional microstructure stability. Dry sliding wear behavior on AA7075/MoS 2 /WC composites was investigated with the aid of pin-on-disc apparatus. Grey Relational Analysis tool was employed to identify the optimal setting of process variables, which results in lower wear rate and COF. The significance of factors such as sliding distance, sliding velocity and load on the wear characteristics was investigated by means of ANOVA. ANOVA results unveiled that load was the majorly influencing factor in attaining optimal wear characteristics. The tested samples have been investigated using scanning electron microscopy and reported.