回転楕円体および角柱でモデル化した飛雪粒子がランダムに方位していると仮定して,スノー・パーティクル・カウンター(SPC)で測定される飛雪流量と真の飛雪流量の比を理論的に求めた.また,粒子形状の異なる雪を使用してSPCとネット式吹雪計による飛雪流量の比較実験を行った.理論的検討より,粒子形状が回転楕円体の場合は非球形度が増すほど,角柱の場合は薄く板状に近づくほど,あるいは細長くなるほど,SPCで測定される飛雪流量はより過大に評価されることが明らかになった.比較実験の結果は理論的検討の結果と整合するものであった.すなわち,飛雪粒子が樹枝状結晶(人工雪)の破壊されたものからなる時は,SPCによる飛雪流量はネット式吹雪計によるものよりかなり大きくなるが,飛雪粒子が粒状の時は両者はほぼ一致する.Sato et al.(1993)による野外におけるSPCとネット式吹雪計の比較観測の結果について,本研究の結果に基づき再検討し,雪面が硬く削剥が生じないような特殊な場合を除けばSPCによる飛雪流量の測定が概ね正確であることを示した.
This paper describes water vapor transfer coefficients related to sublimation and evaporation, and heat transfer coefficients between atmosphere and pavement surface under dry, wet, ice plates and packed snow, obtained from wind tunnel tests and a heat energy balance model. In particular, the contact surface area between an asphalt pavement and a snow/ice layer was taken into consideration in the heat conduction flux supplied from the pavement.Consequently, the roughness heights of four kinds of pavement surfaces mentioned above were obtained. Moreover, the heat and water vapor transfer coefficients were formulated as a function of the friction velocity for each surface.
We conducted an experiment comparing wind speeds and aerodynamic roughness length (z0) values over three snow surface conditions, including a flat smooth surface, a wavy smooth surface, and a wavy surface with fresh snow added, using the wind simulation tunnel at the Shinjo Cryospheric Laboratory in Shinjo, Japan. The results indicate that the measurement location impacts the computed z0 values up to a certain measurement height. When we created small (4 cm high) snow bedforms as waves with a 50 cm period, the computed z0 values varied by up to 35% based on the horizontal sampling location over the wave (furrow versus trough). These computed z0 values for the smooth snow waves were not significantly different than those for the smooth flat snow surface. Fresh snow was then blown over the snow waves. Here, for three of four horizontal sampling locations, the computed z0 values were significantly different over the fresh snow-covered waves as compared to those over the smooth snow waves. Since meteorological stations are usually established over flat land surfaces, a smooth snow surface texture may seem to be an appropriate assumption when calculating z0, but the snowpack surface can vary substantially in space and time. Therefore, the nature of the snow surface geometry should be considered variable when estimating a z0 value, especially for modeling purposes.
1 January 2007 in Journal of the Japanese Society of Snow and Ice