Conventional resistivity inversion methodologies encounter constraints in perpetual monitoring, owing to the necessity for recurrent measurements. In response, this research leverages a 3D finite element method to formulate an approximate geometry imaging of cross-borehole resistivity during forward modelling, circumventing the direct computation of Jacobian matrix equations in the electric field. This study meticulously explores the complex relationship among apparent resistivity (ρ a ), CO 2 resistivity (ρ CO2 ), and the volume of the CO 2 storage area ( V CO2 ). Remarkably, the impact of ρ CO2 on ρ a is found to be more pronounced than that of V CO2 , attributed to the repulsion effect emanating from the high-resistance storage area. A robust linear correlation between ρ a and V CO2 is identified across various multi-horizontal layer models, while the relationship between ρ a and ρ CO2 adheres to a rational function. The intricate correlation between ρ a and CO 2 concentration is dissected, offering a quantitative perspective for inferring the resistivity of the CO 2 storage area. These findings are further validated through field formation models featuring salt caverns, highlighting the effectiveness of cross-borehole resistivity imaging for CO 2 storage monitoring. Beyond enhancing our understanding of subsurface geological behaviour, our study underscores the feasibility of utilizing salt caverns for CO 2 storage, presenting a pioneering approach towards navigating the monitoring of subsurface CO 2 storage.
Dielectric constants can be used to detect hydrates in permafrost regions. Therefore, this study investigated the relationships between the dielectric constant characteristics of sandstone reservoir hydrate and the hydrate saturation degree through physical simulation experiments, as well as the granularity of the surrounding rock. Methane and tetrahydrofuran (THF) hydrates with quartz sands were prepared, and their dielectric constants were analyzed. With different granularities of quartz sands, the dielectric constants of two different methane hydrate sediments decreased with increasing saturation degrees. At a given saturation degree, the dielectric constant of methane hydrate sediments with small granularity was larger than that with medium granularity, a result attributed to the unreacted water in the larger pores of the latter. In addition, the dielectric constant of methane hydrate sediments was larger than that of THF hydrates, which was also attributed to gas-phase factors and the presence of unreacted water. At a given granularity and saturation, the dielectric constants of both the THF and methane hydrates decreased with increasing saturation degrees. We conclude that at low temperature and under normal pressure, THF hydrates cannot be used as a substitute for methane hydrates in laboratory experiments investigating geophysical phenomena.
Revealing the elastic wave properties of carbonate rocks with complex pore structures and improving the reliability of carbonate reservoir descriptions have always been a global challenge in the field of carbonate geophysical exploration. In this study, we established a synthetic borehole model by selecting different particle sizes of cement, carbonate cuttings, and micro-silicon as the matrix, and silicon disks as the pores in carbonate rocks. We conducted four sets of low-porosity (0-3%) borehole models with different pore aspect ratios (ARs) and measured the P- and S-wave velocities ( and ) at the well-logging scale obtained from an acoustic logging system with one source and two receivers. The results indicate that the relationship between velocities and porosities in these borehole models follows a linear relation, with the pore AR significantly influencing the velocities at any given porosity. The velocity variation caused by pore AR reaches 560 m/s and 410 m/s at 3% porosity for the P-wave and S-wave within the AR range of 0.017-0.13. The theoretical DEM models provide a high and broad estimation of and at the well-logging scale in our measurement. They could perform better in fractured formation than in dissolved porous formation in carbonate reservoirs. The linear relation of and is independent of the pore AR and is effective for both fractured and dissolved porous formations. The change of in different pore AR is more responsive to porosity and nonlinear dependent on the pore AR. The relationship between the defined normalized and indicates the pore AR has a more significant effect on than in our model. The constructed borehole models provide a unique opportunity for evaluating the availability of rock physics models at an acoustic logging scale. The study’s findings have significant implications for improving the reliability of carbonate reservoir descriptions and enhancing the accuracy of geophysical exploration in carbonate rocks with complex pore structures.