Enrofloxacin (ENR) is widely used as a synthetic fluoroquinolone antibiotic for disease control in aquatic animals. ENR aptamers were screened in this study using the magnetic bead-SELEX method, and a graphene oxide fluorescent sensor was developed to detect the ENR residues in aquatic products. Firstly, ENR was conjugated to amino magnetic beads by amidation reaction, and then the aptamer sequences showing high affinity to ENR were screened step by step by using the SELEX screening method. Finally, after 10 rounds of SELEX screening, six candidate aptamers with high affinity were obtained. Among these, ENR-Apt 6 was selected based on its secondary structure features, high affinity (Kd = 35.08 nM), and high specificity to ENR. Furthermore, a fluorescent sensor was prepared using graphene oxide and ENR-Apt 6. The results showed that the linear range of the sensor could reach 600 nM (R2 = 0.986), while its optimal linear range was 1–400 nM (R2 = 0.991), with the lowest detection limit of 14.72 nM. The prepared sensor was successfully used for the detection of ENR in real samples, with a recovery range of 83.676–114.992% and a relative standard deviation < 10% for most of the samples.
Ofloxacin (OFL) is widely used in animal husbandry and aquaculture due to its low price and broad spectrum of bacterial inhibition, etc. However, it is difficult to degrade and is retained in animal-derived food products, which are hazardous to human health. In this study, a simple and efficient method was developed for the detection of OFL residues in meat products. OFL coupled with amino magnetic beads by an amination reaction was used as a stationary phase. Aptamer AWO-06, which showed high affinity and specificity for OFL, was screened using the exponential enrichment (SELEX) technique. A fluorescent biosensor was developed by using AWO-06 as a probe and graphene oxide (GO) as a quencher. The OFL detection results could be obtained within 6 min. The linear range was observed in the range of 10–300 nM of the OFL concentration, and the limit of the detection of the sensor was 0.61 nM. Furthermore, the biosensor was stored at room temperature for more than 2 months, and its performance did not change. The developed biosensor in this study is easy to operate and rapid in response, and it is suitable for on-site detection. This study provided a novel method for the detection of OFL residues in meat products.
About Me
Siyuan Wang is a postgraduate student at the School of Ocean Food and Biological Engineering, Jiangsu Ocean University.
Siyuan Wang is a postgraduate student at the School of Ocean Food and Biological Engineering, Jiangsu Ocean University.