Oualid Hammi

Prof. Dr. Oualid Hammi

orcid

Research Focus & Metrics

Academic Career Length

24Years (2003-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
17 November 2009 in IEEE Microwave Magazine
Verified
Journal Article
Closed access
FGFadhel M. Ghannouchi
Fadhel M. Ghannouchi
OHOualid Hammi
Oualid Hammi
In this article, a thorough overview of behavioral modeling and predistortion of dynamic nonlinearities in RF PAs and transmitters was presented. The sensitivity of the DUT behavior to the characteristics of the stimulus was reviewed to ensure appropriate conditions for accurate observation. Nearly all state-of-the-art behavioral models were described and their relative performance and complexity discussed. Similarities and specifics of behavioral modeling and digital predistortion were presented. Thereby, digital predistortion can be seen as a behavioral modeling problem for which performance assessment is much more straightforward. For DUT behavioral modeling, there is no comprehensive metric that allows the model performance evaluation while taking into account the model accuracy in predicting all the three components of the DUT behavior (in-band distortion, static nonlinearity and memory effects). Finally, a software digital predistortion solution that enables closed-loop wideband linearization was briefly presented with excellent linearization capabilities when amplifying a 12-carrier 60-MHZ wide WCDMA signal.

10 February 2011 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
RDRamzi Darraji
Ramzi Darraji
FGFadhel M. Ghannouchi
Fadhel M. Ghannouchi
OHOualid Hammi
Oualid Hammi
In this paper, the novel architecture of a dual-input and digitally driven Doherty amplifier is proposed with the aim of improving the performance of gallium-nitride (GaN) Doherty transmitters. In this work, the power efficiency is enhanced by using digital adaptive phase alignment to compensate for performance degradation due to bias and power-dependant phase misalignment between the carrier and peaking branches. For experimental validation, the proposed dual-input digital Doherty power amplifier (PA) was implemented using a 10-W GaN transistor. Measurement results demonstrate that the dual-input Doherty prototype exhibited a power-added efficiency (PAE) higher than 50% over an 8-dB output power back-off (OPBO) range. In comparison with the conventional fully analog Doherty PA, this represents a 10% improvement in PAE over the same OPBO range. Using a one-carrier Worldwide Interoperability for Microwave Access signal with a 7-dB peak-to-average power ratio, the dual-input Doherty PA, with digital adaptive phase alignment applied at the input of its peaking path, achieved a PAE of 57% at an average output power of 37.8 dBm, along with a - 22-dBc adjacent channel power ratio (ACPR). This corresponds to an improvement of 7% in PAE and 1 dB in average output power for the same ACPR level in comparison with a conventional fully analog Doherty PA.

12 May 2008 in IEEE Microwave and Wireless Components Letters
Verified
Journal Article
Closed access
OHOualid Hammi
Oualid Hammi
FGFadhel M. Ghannouchi
Fadhel M. Ghannouchi
BVBill Vassilakis
Bill Vassilakis
In this letter, a compact envelope-memory polynomial based model, suitable for forward and reverse modeling of weakly nonlinear wireless transmitters and power amplifiers (PAs) exhibiting electrical memory effects, is presented. This model is implemented in a complex gain based architecture and takes advantage of the dependency of PA nonlinearity on the magnitude of the input signal. Contrary to conventional memory polynomials, the proposed model can be implemented in baseband, as well as in radio frequency, digital predistorters. A 100-W average power transmitter is used for experimental validation of the forward and reverse models. Both forward and reverse modeling results obtained with the proposed model are comparable to that of the conventional memory polynomial.

18 August 2009 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
SJSung-Chan Jung
Sung-Chan Jung
OHOualid Hammi
Oualid Hammi
FGFadhel M. Ghannouchi
Fadhel M. Ghannouchi
In this paper, a design optimization approach for gallium-nitride (GaN)-based Doherty power amplifiers (PAs) is proposed to enhance linearizability and maximize the power-added efficiency (PAE) for multicarrier wideband code division multiple access (WCDMA) applications. This is based on the use of an input offset line at the peaking amplifier path to compensate, at a given backoff level, for the bias and power-dependant phase variation through the carrier and peaking paths. At a 6-dB output power backoff (OPBO), measurement results of the unsymmetrical unlinearized Doherty amplifier using a four-carrier WCDMA signal achieved results of close to 50% for the PAE and about -30 dBc for the adjacent channel leakage ratio. Linearization of the designed Doherty PA using a baseband digital predistortion technique led to quasi-perfect cancellation of spectrum regrowth. At an OPBO equal to the input signal's peak-to-average power ratio, -63- and -53-dBc adjacent channel power ratios were obtained when the Doherty amplifier was driven by single- and four-carrier WCDMA signals, respectively. To the best of the authors' knowledge, this represents the best reported results for PAE and linearity for GaN-based Doherty PAs linearized over 20 MHz of instantaneous bandwidth.

8 October 2014 in IEEE Transactions on Microwave Theory and Techniques
Verified
Journal Article
Closed access
AAAbubaker Abdelhafiz
Abubaker Abdelhafiz
AKAndrew Kwan
Andrew Kwan
OHOualid Hammi
Oualid Hammi
FGFadhel M. Ghannouchi
Fadhel M. Ghannouchi
This paper presents a method for pruning power amplifier (PA) behavioral models and digital predistorters based on compressed sampling theory. Using this method, the number of coefficients required by behavioral models and predistorters can be significantly reduced while achieving comparable performance in terms of both modeling accuracy and suppressing distortions. Hardware measurements obtained for a Doherty PA driven by a five-carrier 100-MHz wide long-term evolution-advanced signal demonstrate the capability of the proposed method to linearize a highly nonlinear PA prototype using a minimal number of coefficients, revealing the attractive properties of the proposed method and its desirable performance. Using the proposed technique, predistorters achieving similar linearization performance while requiring significantly less coefficients than the traditional models were demonstrated.

17 May 2010 in IEEE Transactions on Industrial Electronics
Verified
Journal Article
Closed access
MYMayada Younes
Mayada Younes
OHOualid Hammi
Oualid Hammi
AKAndrew Kwan
Andrew Kwan
FGFadhel M. Ghannouchi
Fadhel M. Ghannouchi
This paper introduces a new, accurate, and complexity-reduced three-nonlinear-box model that is suitable for the behavioral modeling and digital predistortion (DPD) of power amplifiers (PAs) exhibiting memory effects. This model is composed of a look-up table (LUT), a memory polynomial (MP), and an envelope MP (EMP), which are all connected in parallel, and it is termed as Parallel-LUT-MP-EMP (PLUME). The PLUME model's performance is experimentally assessed using a highly nonlinear Doherty PA driven by a multicarrier wideband code division multiple access signal. A comparison is held between the PLUME model and different state-of-the-art models reported in the literature, such as the MP model, the parallel twin nonlinear two-box model, and the generalized MP (GMP) model. The experimental results, in both behavioral modeling and DPD applications, demonstrate that the proposed PLUME model outperforms the first two models. However, it shows the same accuracy as the GMP model but with an approximately 45% reduction in the number of coefficients. This significant decrease in coefficients considerably reduces the model computational complexity. Another comparison of the resources utilized for field programmable gate array implementation of the PLUME model and the GMP model is performed, which reveals that the PLUME model uses much fewer resources than the other model.