High‐resolution velocity measurements were collected within and above two dense canopies of mangrove pneumatophore roots in a wave‐exposed mangrove forest. In both canopies, root density decreased steadily with height above bed owing to the variability in root heights and the tapered shape of the roots. Within the canopies, we consider turbulence within three zones: near the bed above the wave boundary layer, around the mean canopy height, and above the canopy. The near‐bed turbulence was particularly intense (up to 6.5 × 10−4 W/kg), likely owing to oscillatory wave‐driven currents flowing past dense vegetation. Near the bed and around the mean canopy height, peaks in horizontal velocity power spectra at frequencies corresponding to Strouhal numbers of ~0.2 may indicate Von Kármán wake shedding in the lee of the pneumatophores. Furthermore, a recirculation zone was observed immediately behind a cluster of pneumatophores at intermediate heights. These coherent flow structures were associated with zones of enhanced Reynolds stresses (up to 5.3 × 10−3 m2/s2) and eddy viscosities (up to 1.9 × 10−3 m2/s). Large near‐bed stresses were associated with near‐bed drag coefficients that are up to an order of magnitude larger than those expected in the absence of vegetation. Observed eddy viscosities are consistent with theoretical expectations, derived from scaling arguments using a standard mixing‐length model. These results suggest that pneumatophore roots can contribute greatly to turbulent mixing (e.g., eddy viscosities were on average O(10−4–10−3 m2/s) and therefore may enhance the sediment transport occurring in mangrove forest fringes.
Coral reefs are effective natural flood barriers that protect adjacent coastal communities. As the need to adapt to rising sea levels, storms, and environmental changes increases, reef restoration may be one of the best tools available to mitigate coastal flooding along tropical coastlines, now and in the future. Reefs act as a barrier to incoming short-wave energy but can amplify low-frequency infragravity waves that, in turn, drive coastal flooding along low-lying tropical coastlines. Here, we investigate whether the spacing of reef restoration elements can be optimized to maximize infragravity wave energy dissipation while minimizing the number of elements—a key factor in the cost of a restoration project. With this goal, we model the hydrodynamics of infragravity wave dissipation over a coral restoration or artificial reef, represented by a canopy of idealized hemispherical roughness elements, using a three-dimensional Navier–Stokes equations solver (OpenFOAM). The results demonstrate that denser canopies of restoration elements produce greater wave dissipation under larger waves with longer periods. Wave dissipation is also frequency-dependent: dense canopies remove wave energy at the predominant wave frequency, whereas sparse canopies remove energy at higher frequencies, and hence are less efficient. We also identify an inflection point in the canopy density–energy dissipation curve that balances optimal energy losses with a minimum number of canopy elements. Through this work, we show that there are an ideal number of restoration elements per across-shore meter of coral reef flat that can be installed to dissipate infragravity wave energy for given incident heights and periods. These results have implications for designing coral reef restoration projects on reef flats that are effective both from a coastal defense and costing standpoint.