Electric cars, like internal combustion vehicles, emit particulate pollution from non-exhaust systems, i.e., tires and brakes, which is included in the Euro 7 emission standard planned for implementation. Tests conducted on chassis dynamometers are accompanied by particulate emissions from non-exhaust systems, which are introduced into the ambient air on the test bench. Particulate emissions tests from non-engine systems on chassis dynamometers are mainly aimed at measuring the mass or number of particulates from tires and brakes. In contrast, little attention is paid to the immission of particulate matter from tires and brakes on the dynamometer during tests, which in the case of electric cars include, for example, measurements of energy consumption or range. Therefore, in order to draw attention to the problem of these emissions, the authors carried out measurements of PM2.5 and PM10 immissions into the air in the climatic chamber during tests of an electric car on a chassis dynamometer. The car tests were carried out in accordance with the WLTC (Worldwide harmonized Light duty Test Cycle) and at constant speed. Based on the test results, a model was proposed for the immission of particulate matter in laboratory air from tire and brake abrasion, taking traffic parameters into account. The results and the developed model show that air quality, in terms of particulate content, deteriorates significantly during testing.
The results of diagnostic tests under steady-state speed conditions of an unloaded engine do not fully reflect the emissivity of vehicles adapted to run on natural gas. Therefore, it is reasonable to pay attention to the emissions performance of these vehicles under dynamic conditions. In this regard, the tests were carried out on a chassis dynamometer with the engine fueled by gasoline and natural gas. Due to the area of operation of natural gas vehicles being usually limited to urban areas, the urban phases of the NEDC (New European Driving Cycle) and WLTC (Worldwide harmonized Light-duty vehicles Test Cycle) were adapted. While CO2 emissions are lower when fueled by natural gas, CH4 emissions can be high, which is related to momentary changes in the composition of the combustible mixture. Although CH4 emissions are higher when the engine runs on natural gas, the CO2eq value is, depending on the driving cycle, about 15–25% lower than when running on petrol. Additionally, studies have shown that in engines adapted to run on CNG (compressed natural gas), it is advisable to consider the use of catalytic converters optimized to run on natural gas, as is the case with vehicles which are factory–adapted to run on CNG.